Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello, We going to run ASA 5516 in HA mode with, but an offer has doubled qty for each part number. Does it really so ?   Part NumberQtyFS-VMW-2-SW-K91CON-ECMU-VMWSW22ASA5516-FTD-BUN2ASA5516-FTD-K92CON-SNT-ASA5K16F2CAB-ACE2SF-ASA-TD6.2.3-K92ASA5516-S...

slyfox by Level 1
  • 1004 Views
  • 4 replies
  • 0 Helpful votes

Hi Team, I have two ASA in Active/Standby but they support Active/Active. My two Internet leased line directly connected to both ASA from L2 switch. and in LAN i have only single network. in this case i just want to use both ISP simultaneously to loa...

NetzKing by Level 1
  • 1560 Views
  • 5 replies
  • 0 Helpful votes

Hi. I am currently using Cisco ACS 5.8 and am setting up vulnerability scanners in my environment.  I would like to ask is there any way to set IP address filtering, or any similar feature to allow my scanner to do an authenticated scan. Specifically...

skyswords by Level 1
  • 968 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Newbie Question

I recently purchased a 5506-X FTD firewall and am having difficulties enabling outside-inside traffic. I want to allow OpenVPN traffic (port 1194) . I opened port 1194 on the outside i/f as shown in the attached screen shot. I then tried a packet tra...

MorrisJM by Level 1
  • 2977 Views
  • 10 replies
  • 0 Helpful votes

I have an ASA 5508-X and my bank offers a complimentary service to scan my network for PCI compliance. Everything has been good for a couple of years now. But last month it failed. I checked the results and my IPSec and SSH ciphers were failing. I up...

Skawilly1 by Level 1
  • 2549 Views
  • 5 replies
  • 0 Helpful votes

Hi all,   I have done with my anyconnect vpn. but after  anyconnect vpn is connected, I can not connect to my asa5506-x using ASDM. i have added management-access inside and it was able to ping but still cannot access.   interface GigabitEthernet1/2 ...

EdwinThoo by Level 1
  • 1357 Views
  • 1 replies
  • 0 Helpful votes

Have an issue with a new ASA 5506W - setup allows internet access to all systems behind it except for the ones with a static NAT - we have separate IP addresses assigned to 2 servers, all the access rules are in place but neither of them have interne...

Jack-ITP by Level 1
  • 651 Views
  • 3 replies
  • 0 Helpful votes

Hello all.   Could you answer me for one questions please . I have Cisco ASA 5525-x in multiple context mode whit three working contexts. Recently we have bought another one Cisco ASA 5525. Now, сan't decide which solutions will be to meet our requir...

amsrus by Level 1
  • 628 Views
  • 2 replies
  • 0 Helpful votes