Network Security

Hi I have a 5545 ASA with firepower service, we currently use L2 design, the sfr module ip address is on the subnet with inside interface and the gateway for the sfr is inside interface as well. now I am trying to add an different  ip address to the ...

Hi All   Im in the middle of upgrading a firewall to a newer 5525X. I transferred the config over but i then realised that the identity certificate has expired in 2016. The CA certificate expires in 2021.    My question is. Do i have to get a new ide...

Trying to troubleshoot why url filtering isn't working for our new FP 4110 boxes. One theory of mine is that the FTD can't perform a DNS lookup, supported by the fact I can't ping or traceroute hostnames from the FTD cli. But I can't for the life of ...

on asa 5545x i have two dmz interfaces one with security level of 50 and the ohter is 75. i am able to ping from lower level to higher level, by default it should be denied if i am not wrong??   Please advise   Regards, MM

Hi,   We have configured a Cisco ASA 5555-X with FirePOWER version 6.0.0.1. The ASA firewall has an ASA OS version 9.2(2)4. This FirePOWER module has been configured with Protect, Control and AMP (TAM License). From the management center, health moni...

Does anyone know of a quick way to test the Firepower IPS/IDS?  I'm trying to trigger it so that I can create a report with some data in it.

I have an older ASA 5510 with the security plus license and version 8.0(3). I just upgraded my ISP bandwidth to 150 Mbps but with auto negotiation it sets the port to 100 Mbps on eth 0/0 but the bandwidth shows 1000 Mbps. The drop-down on the ASDM on...

hi guys, this moment cisco ise 2.3 its running.not is possible reset password for user in the active directory?

Dear All, I was Configuring Pre-Filter Acl in FMC 6.2 for ASA 5525-X, While Configuring ACL, i found that  multiple ACL was created by FMC while viewing Polices in FTD Using CLI. Moreover When Two Users are Installing Pre-Filter Policy in two Differe...

Hi,       In 192.168.2.10  enabled http and https . If source is  is the server (Server accessing hosts outside ),I want to show the source ip is 2.2.2.2 .   object network 192.168.2.10 nat (Inside,Outside) static 2.2.2.2   nat (Inside,Outside) after...