Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Good MorningWe are facing this issue regarding network infrastructure of some customers we take care.In those infrasctructure, only the network layer 3 is allowed to consult an NTP Master Server (as stratum 0 for example). Although this layer 3 devic...

Hello all,I’m currently working with a network that has two ISP's. One ISP is controlled by the State and the other is with ATT. In the past all traffic was going out of the States T1. Now that they have a 2nd ISP, (Much Faster!) I am wanting to have...

Hi All,I am in the process of re-writing the configuration for an ASA using service groups and a new naming convention. Before implementing the new ACL I would like to ensure that it matches all the rules in the current ACL. Is anyone aware of softwa...

c_hullah1 by Community Member
  • 4257 Views
  • 7 replies
  • 0 Helpful votes

Hi All,I have a ASA 5520 with ASDM641. After I updated my JAVA to v7 update 5 , Build 1.7.0; I cannot launch the ASDM and get this Error: Unable to launch the application.I have uninstalled and reinstalled the ASDM to no avail.Any help is appreciated...

Hi Everyone,I'm having a big issue with Nat on my 3925 router. Currently I have 4 interfaces (Internetl, LAN, DMZ & Wifi (which is isolated except for a vew exceptions) on my router which is setup using zone pairs:Internet -> LAN, Internet -> DMZ,  I...

irvine_iain by Community Member
  • 802 Views
  • 2 replies
  • 0 Helpful votes

ASA5510, Can't generate RSA keys, so can't SSH:Any ideas?   ASAXXX(config)# crypto key generate rsa general-keys modulus 1024INFO: The name for the keys will be: <Default-RSA-Key>Keypair generation process begin. Please wait...% Attempt to generate R...

Hello,I have a query on natting on 8.4 ASA. We are going to configure IPsec tunnel with our client. Our client has provided a single ip(192.168.32.11) which would be the source at his end. Is it possible to Nat my end network(10.130.20.0/24) with log...

Anukalp S by Level 7
  • 1046 Views
  • 5 replies
  • 0 Helpful votes
Top Solution Authors
Review Cisco Networking for a $25 gift card