Network Security

Hi,Please confirm the following commands are using for which purpose?interface FastEthernet0/4 description User Connection switchport trunk encapsulation dot1q switchport mode access switchport voice vlan 102 no cdp enable spanning-tree portfastIs Sw...

Hello,i am using Cisco ASA5510 Firewall in my network.  Upgraded the Memory and Flash   to 1GB and 512MB.But the   5 interfaceses  ports are  10mbps.Can it possible to upgrade the module  of Interfaceses from 10mb to 1gb ?Please advice .Thanks,Saroj

Hi Security Experts,Is it possible to reset/recover ISE CLI password from ISE WebGUI? I am able to get into web gui of ISE, but not able to login to its CLI. So want to reset/recover ISE CLI password from its GUI. PS: I rate useful posts.Thanks,Kashi...

Hi,I have Cisco 3560X L3 Switch. We have done Inter VLAN in our internal networks. Below are the VLAN detailsDefault VLAN1 IP 192.168.125.2 (Gi0/1, Gi0/23, Gi0/24)Interface Gi0/1 (Port Configure as a Trunk)Interface VLAN 10 SERVERS_SW (Gi0/2 to 0/6)I...

Hiim sort of at my wits end, ive spent most of the after noon trying to work this out - I got hold of an old pix 501, running following: Hardware:   PIX-501, 16 MB RAM, CPU Am5x86 133 MHzFlash E28F640J3 @ 0x3000000, 8MBBIOS Flash E28F640J3 @ 0xfffd80...

Does anyone know how having two VSGs servicing a single tenant affects the “Host Scalability” of 12 VEMs per VSG?Per the docs each VSG can handle 12 VEMs.I am understanding this as a single VSG module can service up to 12 VEM’s (Hosts). What if the c...

Hey, forksWe have a hosted data center environment. We use dual ASA 5510 for connection going out to Internet. On the internal side of the ASA5510, we use unique VLANs to identify different hosted customers and also isolate traffic among them. Recent...

Hello,I have a client that now requires fips-140-2 compliance. In looking at other post as well as cisco's site. I'm have trouble determining if I need to purchase a fips enclosure in conjunction with the fips labels?This document does speak to the ...

Hi Folks,I have a setup as follows - 2 x Cisco ASA 5525X Series firewalls in an Active/Standby pair2 x Cisco 4948E Switches connected via 2 x TwinAx 10GbE cables (Layer 3)There are approximately 100 VLANs (which must remain seperate) being used in th...

Hi,I am having this issue with the password management on the ASA.  Everything on the ASA is configured according to the Cisco Document.  Now the issue is that when I log in using the anyconnect client or using the webvpn, it does not prompt me that ...

I configured the Anyconnect vpn on the ASA device and I enabled split tunneling with ACE rules to tunnel traffic that matches my INTERNAL and DMZ networks.I set the DNS server to my ISP's provider.I can't seem to get any dns when connected with a cli...

Hi,we are planning on connecting a new aquired company to ours soon?We will connect the remote site to the HQ via a D3. I've been told we will need to have a firewall between them and us for a time. I was thinking of terminating the D3 connection at ...