Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I am trying to use the ASDM to configure my ASA 5510, Each time I try yo lunch the interface at the browser, it got to a point is frozes, please see the attached for the screenshot. Please advice on how to use the ASDM to do the configuration.

Hi folks!Got a PIX 515E firewall with an Unrestricted license. I want to upgrade it to 3DES encryption. I register for the upgrade on the Cisco web site, it recognizes the serial number, and I'm sent an activation key. However, when I go to enter tha...

easyadstom by Community Member
  • 2733 Views
  • 3 replies
  • 0 Helpful votes

I have (2) ASA 5520 Firewalls with three Interface.  Port 0 is used for Outside, and Port 1 is used for Inside Network. Is it possible to used Port 2 for both LAN and Stateful firewall configuration. The idea is to create sub-interfaces on Port 2 suc...

abbas.ali by Level 6
  • 775 Views
  • 1 replies
  • 0 Helpful votes

Hi,we are getting the following messages in our PIX with 8.0.4 SW version: /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99;...

Resolved! VLAN PAIR

Guys I have a little and stupid question.Is there any problem with TCP when using VLAN Pairs. Does the IPS reset the connections? Problem is that I'm doing a PAIR for example from vlan 50 do VLAN 51 when the trafic is originated from vlan 50 it will ...

Running Windows 7 64-bit on corporate laptop w/ docking station with Cisco NAC 4.7.2. NAC works fine identifying and authenticating to production network.at first boot. If system is undocked, the wireless network is detected and NAC refreshes the IP....

jcbrock07 by Community Member
  • 1379 Views
  • 2 replies
  • 0 Helpful votes

Hello!We've  purchased a used Cisco PIX 515E firewall that we are using to replace a  previous firewall of the same model. I have successfully copied the  configuration from the old unit to the new via TFTP. Everything appears  to be working normally...

easyadstom by Community Member
  • 3575 Views
  • 4 replies
  • 0 Helpful votes