Network Security

For sponsor authentication, Active directory is used without SSO.How is the connection between the server and active directory?Is it via AD TLS or AD SSL?Does somebody has more information about this?Best regards

We're using an ASA-5505 and have switched to a DSL line that uses an ActionTec m1000 modem. To pass the static IP block straight through to the ASA the modem needs to be in bridging mode - but when it is a straight pass-through the modem does not sen...

All,I am about to implement GET VPN while read the following from Cisco's website:IPsec transport mode suffers from fragmentation and reassembly limitations and must not be used indeployments where encrypted or clear packets might require fragmentati...

Hi,Is there any limits on amount of translation that pix/asa can handle concurrently. Any commands to see this & for correcting it.Thanks.

I would like to implement SSL VPN through ASA 5520 for the remote users I tired few things and somehow it is not working.

<p>Hello everyone,</p><p>I have an ASA5510 and it's been running fine for a while now. One thing I notice is, on the ASDM Firewall view, I notice sometimes that the Interface facing the Internet (Outside interface) its showing (  ) n/a - config out o...

Who knows why the capture command on the asa 8.0 release does capture packets but is not able to display (or export to wireshark) all packets.The command I use (in several variations)capture cap1 type raw-data buffer 33554432 interface outside circul...

I'd like to configure 2 networks for outside connection so that I can assign diffirent IP's to the inside hosts.The interface configuration is as following,interface Ethernet0/0 no nameif no security-level no ip addressinterface Ethernet0/0.1 vlan 10...

Hello.I bought PIX 501 a week ago - since that time I am trying to configure it - looks like I need some help.The question is:I have an ISP RJ45 wire with single Global IP on it.I have a LAN 192.168.1.0/24I do not have a cisco (or any else) routers.S...

Ok here is the scenerio. I have a public IP address of x.x.x.x that is nat'd to 10.1.1.1. Traffic is sent from the ISP to 10.255.255.2 which is the WAN side of my Sonicwall. The Sonicwall then sends traffic of 10.1.1.0 to IP 172.31.0.2 which is the O...

Hello,As per new security Policy(1) any unsuccessful or successful attempts to Core Backbone switches/routers should be logged and email alert goes to Security Team(2) Any config changes including resetting of password should be logged and Email Aler...

i have two asa 5520 ios version 7.0(8) and i have configured them to work as active stand-by and lan-based but when i wrote "show failover" i found it disabled on the primary one and no replication is done.can anyone help

I noticed that our ASA firewall is showing false SYN attacks. When I look at them, I see such things as our AS400 sending print jobs to a remote facility with an IPSEC tunnel, another example is our PC's connecting to an outsourced content filtering ...

i am working at a customer site whom has an ASA appliance on either side of their DMZ. The inside perimeter ASA is first in the path from the inside networks into the dmz. Then you cross the outside perimeter ASA to get to the Internet.The inside per...

Hi Champs,I would like to know if there is any way to block traffic sourced from an ASA 5540. Basically i am seeing some snnmp authentication failures and the ip address in the message is sourced from ASA. The irony is that i do not have any snmp con...