Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Resolved! VLAN Access List

Hello,As part of a guest access project I have rolled out a Clean Access Server. So when a consultant comes in and needs Internet access she can get it by first logging on the NAC appliance and then is forced into the guest VLAN.So now I need to crea...

Pete89 by Level 5
  • 3690 Views
  • 11 replies
  • 0 Helpful votes

Resolved! Easy VPN on ASA

Dear all,I configured easy VPN on my ASA, but, when i type the following command, it gives  me this error as shown:SA-Gate(config)# crypto ipsec transform-set myset esp-3des esp-md5-hmacThe 3DES/AES algorithms require a VPN-3DES-AES activation key.AS...

Hello All!I have done some searching in the forums regarding my question, but I can't find anything conclusive here or in the documentation.  Here are the particulars with my setup: 1. Each PIX535 firewall pair running 8.0(3) with 8 interfaces (2FE a...

Hello,I have problem with Cisco Router and Security Device Manager",version 2.5. I need create Easy VPN Server by Wizard, but here is a problem,when I click on "Launch Easy VPN Server Wizard" button, nothing happens.The same problem is in other VPN w...

Hi,At the end of the AnyConnect web deployment installation, AnyConnect attempts to connect to the gateway listed in my custom profile and fails with the error "Invalid host entry. Please re-enter". I can see that AnyConnect is trying to establish a ...

I am a newby here so please go easy on me.I am trying to set up my PIX to allow OWA access so basically all I need is port 443 open to a particular server.I have included the PIX config below and was wondering if someone could help point me in the ri...

jcnewman83 by Community Member
  • 2504 Views
  • 7 replies
  • 0 Helpful votes

I have an ASA which has been configured with forwarding all logs to an external attached Syslog server. default udp is being used to have this work. Requirement is to have the firewall log all traffic to this syslog server. But somehow it doesnt seem...

suthomas1 by Level 7
  • 1049 Views
  • 3 replies
  • 0 Helpful votes

Dear All, I am facing some problem while configuring ASA5510 with port forwarding for some inside server. I configured inside and outside interface and dynamic NAT for inside users to use internet. But when I am trying to configure port forwarding fo...

eahmed007 by Level 3
  • 739 Views
  • 2 replies
  • 0 Helpful votes

Hi,  I would like to ask some help because I will replace our RouterFirewall to PIX515 firewall. I know that this an old one but we need to  do this for security reason as we are waiting for the new equipments to arrive. Below are my inquiries.1. Whe...

Mon Baul by Level 3
  • 940 Views
  • 2 replies
  • 0 Helpful votes