Network Security

I have an old PIX 501 with PIX OS 6.3 Is that any limitation when statically translate UDP ports, right now I'm doing IP-to-IP NAT but only some ports are opened. Any suggestions? Regards, Omar

Hi netpro'sI am having a nightmare time trying to get some static nat working on the pix...I have PIX 515 V8.2inside i have 192.168.204.0 /22 networkoutside I have 192.168.1.0 /24 networkthe outside interface is connected to a cisco 877 router with a...

Hi all,I would like to implement the following config on a 501 Pix: on the outside interface of my PIX which is in location b, I have two vpn tunnels going to two separate locations, a and c. Now I would like, through these tunnels, a to be able to c...

HelloWe have setup a ASA 5505 at a remote remote that VPNs into our core ASA5520.The 5505 is connect by a static IP to standard broadband.Everyting works well extent that we can't Putty onto the external interface.Attached is our config - does anyone...

Hi there, i've got a situation - i have an acl "xxx" with only 4 "permit" line's.When i try to apply this acl to the static address translation with command (static (SAP,outside) 3.3.3.3 access-list xxx) i get an error message (ERROR: access-list con...

Hello, I'm working on an ASA that is at 8.0(4)32 and ASDM 6.1(5)57. Below are the logging statements I have in the config:logging enablelogging timestamplogging standbylogging buffer-size 32000logging buffered informationallogging trap debuggingloggi...

We are in the beginning stages of looking to implement NAC. Our network consists of 88 locations all on the same LAN. We want to implement OOB however we have run into a snag where there are an average of 20-30 unmanaged switches at each location tha...

Guys, i got a NAC manager appliance from cisco on which the NAC manager is installed. I configured failover on the server and during reboot, the boot stops at the line below and doesn't continue th enormal boot procedure: EXT3-fs: mounted filesystem ...

Hi, We observed atter rebooting or reloading the primary box failover related configuration is automatically removing from the primary box. H/W model Pix-525 and image ver: 6.3.5 It will very help me if some can help me on this.

Hi All,We have a problem using the ASDM to managae our ASA'S. It stopped working suddenly and everytime we try to use it will stop after trying to load the current configuration. I have tried clearing the ASDM cache and internal log buffer but still ...

Hi,Similar to statements put in routers for allowing internet based segment to access services hosted inside the network,firewall uses the static command ( if am correct).My query is , if the inside server is hosting service on port 344( eg.) then sh...