Network Security

Our company has a Pix 501 and even though I installed it and configured it, I wouldn't say I know what I am doing. Please bear that in mind. I have two questions. One, while using the PDM to change the firewall's inside IP address, it seemed that I c...

I just recently upgraded to version 8.2 on our ASA's and can no longer see the syslog id of 106100.When checking under "syslog setup" the entry is there but has the logging level as N/A and will not allow me to change it.Any one else or how do I fix ...

I wonder if anybody tried to run ibm pcomm application over smart tunnel to connect to the mainframe. It is telnet like software. I am trying to make it work but I think I am missing something. By the way I can RDP to Wintel on the same subnet. It wo...

Hi there, I wondered if there's a way to make a VPN cluster with IOS router like ASA does, in order to load-balance incomming connection between routers. I think a solution would be to use external switch with a CSM module, but is there any built-in ...

Hi,We are attempting to move from the old Security Monitor in Cisco Works VMS to the realtime monitor (IPS Event Viewer) within CSM. The problem we are getting is a subscription error from the sensors when trying to open the realtime monitor.Error Ou...

I have the need to NAT an inside address (DMZ acutally) to two different outside addresses- one outside address is just for internet access, the other one is a NATed address on a VPN L2L tunnel. So I want 10.10.10.1 to translate to 192.168.1.1 if goi...

I have a new ASA installed at a client that is running 8.2. Whenever I am in the ASDM looking at the log monitor, the syslog connection keeps dropping every few minutes. I 8.2 running at other clients and do not have an issue. Any help would be great...

Hello,One of our PIX firewalled recently failed over. Since it happened, it constantly dipslays the sync status message:.............................................Sync CompletedSync Started.............................................Sync Completed...

What are the security advantages to make NAT between DMZ and inside??Thanks a lot

Hi All,I have an AIPSSM IPS module installed on an ASA-5510.I can access the module through the ASA's backplane using the 'session' command.I followed the setup and assigned a management IP.I can access the ASDM using the ASA's IP address, but when I...

Hi,I just wish to ask how to update the signature files of the IPS (SSM) module attached to the ASA. Also, do these signature files include the antivirus signatures? Thanks in advance.

Hi,After shutdown the sensor from IME gui under configuration > sensor mgmt, sensor was accessable only from console.Can't even ping to it.Please help. Thanks,

Dear AllI am binding the policy in ASA 5500, everthing works fine except we are not able to download the mail attachment from MSN.The ASA OS Version is 8.2(1).regex domainlist2 ".*sandai.*"regex domainlist4 ".*megaupload.*"regex domainlist5 ".*sendsp...

Dear All,I would like to know that how can i know detail of command on Cisco ASA, like command as below:crypto isakmp policy 1 authentication pre-share encryption 3des hash sha group 1 lifetime 86400------------A lot of command that i don't know like...

Hello, I have a ASA5505-UL-BUN-K9 and i want to implement Anyconnect(oonly tunnel mode), but i am not sure what licenses i need. Do I should to buy a " ASA-AC-E-5505=" license? or do i need anything else?. If my ASA doesn't have "Security Plus licens...