Network Security

Please help :?:I have a cisco asa 5510 firewall and I am trying, with not success, to configure it so allowing rdp connections (3389 port) from outside to have access to internal server located at DMZ.Could somebody help me with this ??Thanks,

Hi, I am looking a solution to block all P2P and bittorrent traffic by ASA FW (8.03 ver) and allow only a single machine in the network which is not to be blocked by ASA. Please suggest...

Hello, I'm running version 8.04 on the ASA5510 and would like to add new subnets to the VPN network group. Please point me in the right direction.Thank you so much!

Hi, Please let me know, can i access ASDM/sshfrom inside host to Managment interface?Thank you,Zafar

Hello,i'm trying to configure portforwarding on our ASA5510 with ASA Software 8.0(4) and ASDM Version 6.1(5)51I've configured a portforwarding list with "local tcp port" 3044 Remote-Server is the ip of the server, where the user should be able to con...

Cisco config guide for asa ver 8 software states; "You can configure an IP address for the Management 0/0 management-only interface. This IP address can be on a separate subnet from the main management IP address."If we set the global IP to fall in t...

Hi All,I need to reach a remote network that permits traffic from my public IP address. When I am on the road I need to access the same system. My solution (or at least what I thought would work) was to VPN into my corp network and then access the re...

Hi All,Can I block Skype using my ASA? If so, how can I do it? Thank you all!

Is it possible to allow split tunnelling for certain remote access VPN users to only 1 website? In other words, the users can access 1 public website while connected via the remote access VPN.

we are using pix 5151e 7.2 (3) version and we configured the statefull failover between two pIX 515E and its working fine but my query is when i give command sh failover it showing only the primary unit IP all interface but not the secondary unitplea...

Recently attempted upgrade to 8.0.4 but had to downgrade because I could not get ssh working at least from the outside interface. Tried zeroize and generate to no avail. Anyone have this?

How can I backup the configuration of the ASA 5505 on 8.x and restore it to another ASA 5505 with same version? I have tried to save the running config to a file and then copy it to the new device and use the boot config: filename but it doesn't work...

Dear all,Video & voice is not clear in telepresence device, using ASA between inside & outside. how to configure QoS for this scenario.thanks & regards,

access-list incoming extended permit tcp any host 7.17.20.9 eq smtp static (inside,outside) tcp interface smtp 10.1.40.5 smtp netmask 255.255.255.255 Have the above lines in an ASA. Yet when I try to test if port 25 is open by doing "telnet 7.17.20.9...