Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
Our primary unit failed over yesterday stating communication failure, but I want to failback. I used the failover active command, but I'm assuming that is not going to work since failover seems to be 'off'.FW-IN01# sh failoverFailover OffFailover un...
I am trying to get isakmp/ipsec to work between two Cisco routers. One router has a static public IP, the other router is on a 1-1 NAT behind an ASA5510. The 5510 is using standard Fe0/0 for outside and Fe1/0 inside. I have allowed all of the neede...
We are laying out our new DMZ and wanted to know what is the recommended approach for setting up our web servers and database servers? Should the web servers (front-end) be placed in one DMZ and the database servers (backend) be placed in a seperate ...
Hi I'm trying to add downloadable ACL's via a LDAP map. I have done a map between the info attribute in Microsoft ActiveDirectory and the Cisco-AV-Pair field.My problem is that when I add two lines in the configuration i recive an error in the ASA lo...
Dear All ,I have two ASA's connected in a failover mode .The issue is that when the inside -switch 1 goes down active ASA (ASA-A ) is not coming to standby mode. On the active ASA , I have made the configuration to monitor both inside and outside ...
im trying to access the ASA 5520 and getting the attached error ? any clues ? . I can telnet to the ASA without any issue . before i was able to access to ASA from same PC without any issues
I have a ASA5550 en would like that max 100 users with a bandwidth of max 4Mbit can setting up a VPN session. Is this possible and how can I configure this.I have already setup the max IPsec connections of 100 sessions.But I can't find out how I nee...
For an initial install I have configured to log all attacker/victim pair packets investigating events in detail and not meant to be on all the time. It will be turned off to see if this reduces the amount of storage space that is being consumed so we...
Got a PIX 506E configured for VPN Client Access.VPN Client connects however cannot ping anything on the LAN.Confirmed config with other Cisco Docs and is okay. Please help
I am trying to conifgure WCCP to work with squid. i have the following config for wccp so far:access-list Wccp extended permit tcp any any eq www wccp web-cache redirect-list Wccp group-list Wccp password foohere is the show wccp:Global WCCP informat...
I'm new to Cisco NAC appliance.I wanted to deploy L2 OOB VGM for my wired userd.I wanted to check whether can I have multple Authentication to Access VLAN mapping.For example :Authentication VLAN - 111 Map to Trusted VLAN 311andAuthentication VLAN -...
We're having issues with a PIX 501 not wanting to let traffic thru a tunnel.I'm pretty sure it has to do with nat and nat traversal or no nat ... etc.if my internal network is 192.168.X.0/24 and my WAN1 ip is 76.77.78.79, and that the WAN1 ip is comi...
