Hi Tech People,we have installed a Firepower 2140 in HA environment. I have a problem in showing all interfaces from the Secondary Firewall. I can see only the following Interfaces NIM (4x10G in NIM 1 Module) on the Primary firewall which is 1/13,1/1...
Dear All, I am having issues login to FTD CLI. I am getting below error while trying to do so. Can someone please help?
I have two ASA running in HA.So usually during HA one will be acting as secondary and one as Primary.That is Primary-active and Secondary -stand by or Secondary-Active and Primary -Standby.I want to change the role and not just the state, how to achi...
HIOur FMC 1000 is stuck updating GeoDB is there any way I can stop this and try a manual update please.
Hi Community,Is there a way to load balance our dual WAN ISP in cisco firepower 1120? If yes, how to configure it? Thank you.
We have an ASA 5508 running 7.0.4 FTD code and managed by FDM. I used this guide to configure Duo:https://networkwizkid.com/2021/12/16/configuring-duo-two-factor-authentication-2fa-for-cisco-remote-access-vpns-ra-vpn-using-the-firepower-device-manage...
We're looking at buying a Cisco 2130 NGFW. The plan is to connect using the SFP+ on the firewall to SFP+ on a Dell N3224T-ON, is there any reason not to use one of the uplink ports on a switch to connect these two devices together? We're wanting to g...
Good morning or afternoon, everyone.I have an ASA 5545-X that is reloading constantly and with a 'no boot image' to load from. I reset it to factory defaults and reloaded/restarted it, that was yesterday morning. I have put it into 0x41 & 0X1 and tri...
Hello community, as rumors go, EOS for the ASA 5506 is within reach. If you belong to the group using ASA 5506 with Firepower Services, this will kinda feel like the end of life as we know it. At least to anyone firewalling the bejesus out of the ASA...
Hi, After a power outage and issues with the UPS, we see an issue with failover. The first thing I noticed when login in to the CLI of the secondary firewall, was this message - "You have logged in while system startup is in progress. Please wait, ...
Hi,I have an ASA 5520 on FW 9.0(4).I have on it 3 subnets : inside (10.1.1.0/24)outside (1.1.1.2/28, webserver Public ip 1.1.1.3)DMZ (20.1.1.0, webserver DMZ ip 20.1.1.10)Clients on the inside are able to access internet without any issueWebserver lo...
I have a number of Cisco ASA devices that i want to upgrade the ASA/ASDM software on.The all run in active / standby mode.I have a mixture of ASA5525-X, ASA5545-X and ASA5555-X devices.They all run:Current ASA version = 9.8(4)10Current ASDM = 7.13(1)...
a web site we use is using HTTP. when it reaches its destination its redirected to HTTPS. Cisco FTD IPS policy is blocking the redirect. how do we enable this through IPS?
Please guide me for changing TLS version on Cisco sf300 sw version 1.4.2.4
Hi All, I'm in the middle of integrating log sources into LogPoint, where FMC is one of them.Logpoint has FMC on their list of integrations, but I'm not able to finde any documentation? I'm a bit reluctant to setup syslog in every policy and so forth...
