Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

1. Why doesn't "drop log" policy-map action send unreachables? Is this a bug or feature?2. Why doesn't ZPF control multicasts terminated at the self zone (EIGRP, for example), so it is not possible to control which multicasts are accepted and which a...

ovt by • Level 8
  • 1124 Views
  • 2 replies
  • 0 Helpful votes

I'm scehdule dfor some training on the appliance next week. Meanwhile ..Does the appliance_need_to be managed via the Management interface? Can I run ASDM from the inside interface w/o issue? IOW, is there a good reason for providing the management i...

demo20dog by • Community Member
  • 758 Views
  • 2 replies
  • 0 Helpful votes

Recently, we are trying to setup a L2L connection to a vendor. We are in 192.168.1.0 network but the vendor is in 10.10.100.0 subnet. Because the vendor doesn't want to route my 192.168.1.0 network in their network, they want us to translate our subn...

donlin123 by • Community Member
  • 536 Views
  • 1 replies
  • 0 Helpful votes

We currently have a 3015 doing our VPNs. We are looking to move that to our 5520. RADIUS with password epiry is being used for authentication on the 3015 and we would like to continue to use it. Reading the docs for the ASA I have found conflicting a...

admin_2 by • Level 7
  • 1037 Views
  • 2 replies
  • 0 Helpful votes

I can session 1 into the SSM 10 from the host ASA 5520, run setup and ping the ASA and a device hanging off the dmz but I can't ping the SSM-10 from the ASA or a host hanging off the dmz. I don't have the RJ-45 of the SSM plugged into the network. I ...

mlenco by • Level 4
  • 1135 Views
  • 2 replies
  • 0 Helpful votes

Hi,I'm pretty new on using Cisco routers, the guy that was in charge of this left and I'm supposed to take care of our Cisco 2811.I'm trying to add a rule that allows unrestricted access from the whole subnet 192.168.0.0 /255.255.0.0 to certain range...

mic.adrian by • Community Member
  • 1131 Views
  • 4 replies
  • 0 Helpful votes

Cisco PIX Firewall Version 6.3My PIX was working just fine until I enabled PPPoE. Now that I've enabled PPPoE, I can no longer ping out. Now when I Ping out, I don't get responses back.I tried disabling ip audit, permit icmp any any, I even tried per...

Resolved! PPPoE & ACLs

Cisco PIX Firewall Version 6.3 I recently enabled PPPoE and now my ACLs no longer permit incoming traffic to my public hosts (Outgoing traffic is fine). I tried disabling 'ip audit', changing my static statements from 'interface' to the IP address, I...

Review Cisco Networking for a $25 gift card