Network Security

Hi,I've got to install a 50 user license on our 10 user PIX 501 but I've stumbled at the first hurdle!!!The first thing the instructions say is go to "http://www.cisco.com/go/license" then follow the steps listed on the web page. Unfortunately that U...

Hellohow an IPS Sensor appliance can get data? As far as i know via span port from a LAN switch. What about inline capture, is that possible?

We need to split a 100M ISP ethernet connection into 10Meg for Internet access and 90Meg for a DR site-to-site vpnWas thinking along the lines of this config...class-map vpnsite-site match tunnel-group xxx.xxx.xxx.xxx policy map qos class vpnsite-sit...

Hi,I really don't much about any of this as I'm new to hardware firewalls and routers so any help is greatly appreciated.I have a SBS 2003 server which connects to the internet via a 2nd NIC card in the server. The 2nd NIC is connected to the interna...

hi i have a problem. i had got some servers on the pix dmz interface. now my pdc is on the inside interface. i want that our servers which r in dmz interface should be able to authenticated with the pdc which is in the dmz . please tell me the soluti...

Greetings all!I have a 4235 appliance running 4.1(1)S47 For a long time a device worked normally, but suddenly it began to give out strange statistics. Particularly, on CLI command " show interface sensing" appears the following message:"Sensing int0...

The ASA configuration guide states that in transparent mode:"The transparent security appliance uses an inside interface and an outside interface only. If your platform includes a dedicated management interface, you can also configure the management ...

HI,i am planning an pix (2 nodes in failover) in transparent mode, multiple context from version 7.01 to version 7.02 but i have not find any doc for this type of upgrade. the available doc is from 6.3 to version 7. Here is few issues that i need to ...

Does anyone have a Comparison doc. between Cisco PIX Fireawall and Symantec Gateway Security Firewall appliance ??RegardsMohamed

Does anyone know if ASDM has different levels of security know. For example, can make some users with read-only access and some with access to everything. On PDM it is an all or nothing thing. Specifically, I want users to be able to reset VPN tunnel...

Cisco Secure PIX Firewall BIOS (4.0) #0: Thu Mar 2 22:59:20 PST 2000Platform PIX-515Flash=i28F640J5 @ 0x300Use BREAK or ESC to interrupt flash boot.Use SPACE to begin flash boot immediately.Reading 1921536 bytes of image from flash.##################...

Am I missing something here?interface GigabitEthernet0/0 nameif outside security-level 0!interface GigabitEthernet0/1 nameif inside security-level 100!interface GigabitEthernet0/3 description LAN Failover Interface!access-list OutsideIN extended perm...

Hi,I am installing and configuring LMS 2.5 on solaris 2.8 paltform. I am facing problem with RCP image transfer in all my Cisco devices. I configured the router with the following commands:username xxxx password xxxx ip rcmd rcp-enable ip rcmd remote...

what software can I use to monitor the VPN status of my cisco pix 515E?