Network Security

I have a PIX 501 thru which I need to forward traffic from the outside to two servers on the inside network. My outside address in this case will be xxx.xxx.xxx.xxx and the inside addressing range is 192.168.125.x and I want to allow remote assistanc...

Hello,I'm a real noob here so please bear with me.I have been able to configure my PIX 515E to allow VPN connections onto my network, but what I need to do is set up some sort of user authentication to control access at a user level. From what I've r...

I'm trying to setup a DMZ host to have access to a public interface translation for a host in another DMZ. Is this possible on PIX? For example:public IP for dmz_b host 192.168.1.5dmz_a host 10.1.1.5dmz_b host 10.1.2.5I'd like to configre dmz_a host ...

Hi What do I do if our VPN clients complain about the link being slow and the connection dropping off.

I installed the S219 updates on one of our client's IDSes. After the install, the eth0 (sniffing) interface started bouncing. I'm getting the following errors constantly (i.e. 2300 in 2 hours)evError: eventId=1084139354956127055 severity=warning orig...

After upgrading to 5.1-1c when I enter a "sh Ver" it still reports version 5.1-1. Is this normal will it not show the rev c

i have cisco 515 pix firewall having 4.4(8) IOS. This (PIX or IOS) does not provide secondary IP address i.e can't assign more than one ip addresses to one interface. How can i assign more than one IP addresses. Do i need to upgrade IOS? if Yes, then...

Hi I have installed 515 pix firewall.I just configure it. but my question is by defult which of attack are protect by pix ?.we found many network attack.so how pix protect this attack.ThanksBiplob

I am curious to know if anyone knows how failover works with the AIP-SSM module? Do both SSMs need to be configured with the same address or do I configure a different address for both? Also, should I run a full setup on the failover's SSM or is that...

Hello,I wants to establish VPN tunneling between my office and my remote headquater.i have VPN 3005 concerntrator at my office and 525 PIX at my Headquater.Can any body give me any solution or any links that i can go through.i wan to create tunnel be...

Greetings,I've been trying to look for anything relating to this over the Internet, but could not find anything. Is it possible to map MAC addresses to certain ports/interfaces on a PIX, if so, can someone please point me to the right direction?Thank...

We have a customer running CSA 4.5. We used the CSA starter kit which include VMS .Customer purchased additional client licenses.But, when we take a look at the licensing on the VMS server, we see that common services expires in 90 days.Is there some...

I see that VMS 2.3 is now EOL/EOS. From Cisco documentation it appears that Cisco Security Manager and MARS are the replacement.Since VMS 2.3 basic with 5 device support was included with IPS sensors at no charge (IPS sensors are basically plug and f...

Hi,I have a PIX 515 w/ 6.3(3) running close to 100 IPSec tunnels. The problem I run into is, we connect to internal devices on customer sites with the same internal IP address. My current solution is to have the customer do a static/policy based NAT ...

Hello everybody!,I have installed a Cisco 2821 Router with 12.4(4)T IOS version. And SDM V2.2.a. (enteprise service IOS image).The router have 256MB Ram and 64MB flash memory.From the SDM Interface cannot upload any .sdf file and cannot edit the sign...