Network Security

Hi,I need some help with a Pix config.I have a Pix with inside, outside and DMZ interfaces.I have a server in the DMZ, that I need to grant access to users from the inside network and from the Internet.As users inside and outside must use the same DN...

I have a 4215 that is inline outside our PIX. The bandwidth is 1.54mb. I also have FastEthernet0/1 sniffing (via a SPAN port) the ethernet interface of our WAN router. The Wan routers ethernet int is 100mb. I suspect I am oversubscribing this unit an...

I installed ciscoworks 2.2 with SP3 using VMS 2.3 CD . I installed router MC, IDS MC, Secmon, etc using VMS 2.3. I logged into ciscoworks but can not find IPSMC. I found IDSMC but no IPSMC . According to VMS 2.3 CDm IPSMC is included in the install....

We have a VPN set up with our office running successfully through PIX 501. Remote users connect ok using the VPN and MS Remote Desktop on PC's. One user who uses MS Remote Desktop on a home pc and an IBM laptop is able to connect from home through a ...

I've many alarms with more than one signature with destination ip address 0.0.0.0 source and destination port 0how can I intend these messages?

I need a sw to analyse a pix 515 traffic log.Where can I find it? Is possible to have a try version to test it?

I would like to have some help to configure a VPN for 2 cisco 836. The scenario is as follows:SITE1 -> CISCO836 -> ISP {INTERNET} ISP -> CISCO836 -> SITE2;The LAN SITE1 should be available on the LAN SITE2 and vice-versa.I would like to thank you for...

Which are the main differencesbetween PIX FW and the new ASA55xx ?Will the ASA55xx in the future take the place of PIX family orwill the two products coexist ?Which the criteria to choose between them ?Thanks to anyone will answer.Alessandro Asson

Hello all,I'm trying to configure a SPAN monitor session on a 7606 router. interface GigabitEthernet3/7 description to IDS01 SPAN Port no ip address speed 1000 duplex full switchport switchport trunk allowed vlan 4,5 switchport mode trunk spanning-...

I need some help configuring SSL packets forwarded to a webserver. The problem is that the pix is live and is already forwarding SMTP to mail. but we need to use the same ip which the mail server utilizes for SSL web.The xternal pool available isext....

hi,i have a PIX 525 with 2 FE ports and 1 Gig Port. I wanted to use the GIG as the inside interface. Is it possible to swap the Inside from Fe to GIG and used the FE for DMZ?regds,T Singh

Hi, that's the Problem:When I try to connect MSN it's not possible.I saw that on the firewall:---305011: Built dynamic TCP translation from inside:inside-ip/1166 to outside:outside-ip/55586302013: Built outbound TCP connection 75493 for outside:65.54...

When I am configuring two firewalls in failover, do I have to use three IP adreses per interface pair or I can go only with one, real one? Problem is that behind my firewall I have routers and I used 30 bits IP subclass. And now I want to add failove...

Hi All,We have been using Cisco PIX's for more than 5 years now, and vpn tunnels have been part of many configurations through time. Now I finally got brave enough and upgraded a pix to PIX OS 7.0.2 from 6.3(5)It was a mess to change the configuratio...