Network Security

Can anybody explain, why cisco introduced SDEE in IOS routers? What is bad with RDEP?Thx,Oleg Tipisov,Redcenter,Moscow

I need to develop a few CSA testing procedures to demonstrate to others the workings of CSA. This would include attacking a workstation protected by CSA with certain viruses. Has anybody develop anything like this and willing to share it with me?Or a...

It doesn't seem like any of these applications are supported under Windows 2003. Is there any work around for this or is it going to be supported any time in the future? Thanks.

Could any suggest a good third party RADIUS Server that supports all Cisco Devices

I continually find my dsl down at home. This is the log I get from the pix:<163>Jan 16 2005 06:31:48: %PIX-3-403503:PPPoE:PPP link down:<163>Jan 16 2005 06:31:48: %PIX-3-403503:PPPoE:PPP link down:Peer not responding<163>Jan 16 2005 06:31:48: %PIX-3-...

Is it possibel to run LMS, VMS or ACS under VMware?What´s about the performance?Are there any restrictions?RegardsJoerg

Can any pix models support multiple IP's on the outside interface? I'm looking to have two different ISP feeds and want to enable a primary and secondary vpn tunnel.NOTE: I noticed an earlier conversation pointed out that with version 6.3 and above ...

internet--router1---pix---router2----lanFrom my lan,I can only ping to inside inter of pix from pix I can only ping to r1 , but I can ping to my Lan.It`s look that I have a configuration problemes in pix.I need help for this , I have tried ...fixup p...

I am having problems with a new PIX 501. The pix stops transmitting requests from inside to outside for one group of hosts at random times. Sometimes it will work for just a few minutes and sometimes it will work for over an hour. I can always get in...

HiI have recently installed a mail server and would like to forward SMTP traffic through my 831 router and then again through my pix firewall to the internal network?The configuration is a follows: I have 831 router that is connected to my cable mode...

Hello everybody, my problem is really simple, I don't know with a Router 2620 and a Firewall 515E how to plug my IDS, Do I need another switch between the Router and Firewall for this to work, is that the best way, please help.

I installed CSA MC on a server that is in our DMZ. I forgot to set the FQDN of the server before installing VMS. The server's name is in our inside and outside DNS servers. All of my hosts that are part of that domain can register with the MC, but...

I need to give access to OWA on an internal server to mobile users. I am using the Cisco GUI PDM. How do I give access to the server? Is it just forwarding port 80?

Hi,I installed my new VMS server without any errors (IDSMC 2.0 SecMon2.0). As I log in and click on the Security Monitor or the IDS Management, it tells me, that the page cannot be displayed.Do you have any idea or advice?Thanks!