Network Security

Greetings,I am thinking about setting up a redundant internet presence with our ISP. They will provide two routers and they will be using BGP between them. I have two PIX 515 firewalls that will sit in between those routers and our internal network...

I have a 3005 configured for wireless network on the external interface. I am trying to get clients on that network to recieve DCHP addresses from a server on the internal network.I have DHCP relay turned on to the correct server (and it pings back)...

Hello,is it possible to have a PIX cable failover with a PIX 6.2 and a PIX 6.3?

Hi EveryoneI have this scenario, i actually took a incomplete sample out of some CCO documentation : R1 ---------outside -- PiX -------- inside----- R2 | | DMZ ...

plz I want a help for PIX 501 configuratinthe os is 6.3 device maneger 3

Good morningPlease can someone give me some assistance?Is it possible to do web content filtering on the cisco pix actually on box or do I need to back this off to websense?

I have a PIX 501 that has been behaving normally for months. Over the last few days we have been losing our connection and it seems that the PIX is the culprit. The internal interface seems to shut down completely, connecting to the PIX via the con...

I have a requirement to allow an external server to forward requests on port 2799 (ODBTP) to a local server behind our PIX-501.I've attempted to do this but all I manage to do is block all outbound access to the Internet!Any help would be great, than...

Hi community,We configured our 515 PIX to accept VPN Clients (3.6.6 and above) connections, and we do not have any problem to get to the 'inside' and to browse the LAN. Our problem is to get out through the outside with an IP address of the VPN local...

We are in the process of installing a PIX 515E (running ver 6.3.1).We are currently only using 2 interfaces, an inside (LAN) interface and outside (Internet) interface. There is a 3rd interface, but this is currently not in use.The inside interface o...

Good Day everyoneI have this situation:A core switch 3550, with 4 VLANs, connected to PIX through a dedicated VLAN.All the clients in each VLAN could ping the inside interface of the PIX, but when they want to browse the internet they couldn't I thin...

Cant the PIX firewall be configured w/out NAT?

we hav rwan 1.3 and acl 1.5. Does this supposed to support PIX 515? If it is, what are the minimum command I must configure on the pix. I already have the SNMP-server host XXXXSNMP-server community publicthanks a lot

hello,we installed LMS 2.2 and along with the managed device is the pix 515. It says on the SNMP section of the pix the it supports at least the GET command..Isnt this is all I need to have to enable LMS to view at least the configuration of the fire...

Hi, We have two main sites with a PIX515 in each site. Both Inside interfaces are on the backbone OSPF area (0) & the Outside Interfaces are in different OSPF areas (51 & 53). The two sites are connected together by our internal network on the Inside...