Network Security

We have a need to use another VPN hardware/software solution. However, in order to use this other solution we need to be able to configure the 501 to pass the NATT'ed address 192.... to the VPN hardware in front of it.

I have multiple customers that will accessing my network via VPN. I am using a 7204 which resides behind two of my BGP routers. I would like to allocate a specific amount of bandwidth per customer. Is there any way to do this with IOS based vpns?Than...

Our case goes like this:In one of inside networks an NT box had a record of an FTP session (Close Wait) from an internet host with a public address. Is there a way in which this host could bypass the pix? The NT box is for internal use only and it is...

Is there any version of the PIX that allows this???

I have installed the 2nd CD One,but it's ANI Server is down,Now I have 4th CD One,Can I upgrade from 2nd to 4th directly?when upgrade is finished,the ANI Server will be restarted?or I must remove 2nd and later install 4th?

can someone please confirm or correct me on this. i have an IP addy that has been scanning my network off/on for a few hours. i have already contacted the administrator for this IP's network(a college campus) via email and left him a voicemail, but h...

DSL into 826. Winproxy and 1720 into 826. 1. Can the 826 prevent VPN traffic while allowing web traffic to flow thru Proxy?2. Does the Proxy server setting in IE connection override default gateway IP?The problem is that VPN clients have Default GW a...

Hello,How can I get the PIX log to show a timestamp that shows the time and date.I get a strange #. Below is my show clock and show log output.thanks,rrc> PIX(config)# sh logg> Syslog logging: enabled> Facility: 20> Timestamp logging: enabled> Standb...

I would like to know if SNMP packages are available in order to monitor IPVPN/MPLS base connection? What MIBS do I need to load into my SNMP central agent?

I have a PIX 515E (2 interfaces) and I need to route SSH (port 22) traffic inbound to an internal host.Even though I have entered the command to allow SSH in the access list the PIX still blocks the traffic. All other services work fine (port 80,25)....

can I open telnet session with PIX from outside ??and how can this be doneso i can telnet to the PIX from any IP ?and if this can be done can i add any security so to compensate for openning such a hole in my firewall

Dear All,We have the following scenario:DHCP Server --- PIX515 ---- Internet ---- VPN Client1. VPN Client terminates the tunnel to the PIX.2. PIX assign an internal IP address to the client.3. The pool IP address is received from internal DHCP server...

I have cisco pix firewall which i have configured for both site to site and site to clinet. Clients are able to connect using vpn client but when i have a site to site with customer's firewall(Symantec) and when i try to ping his internal ip address ...

hi,I have CiscoWorks 2000 LMI1 , with CiscoView 5.3In my 7206 VXR router there is two Escon Channel [ PA-4C-E] , in the default packages of the CiscoWorks 2000 LMI, this card is not supported , so I downloaded the Rtr7000.cv50.v13-0.zip ....the probl...

I am trying to create a VPN between a Cisco 1721 and 827 (ios 12.2(8))and have tried Setting the 1721 up as a Easy VPN Server and the 827 in both Client and Network-Extension mode and the Client gets the DHCP pool from the server but there is no traf...