Network Security

I have a PIX 520 running 5.1(4). Have the statements necessary to set up IPSec VPN with pre-shared key. Company wants to allow access by outsiders. I Have ACE server doing TACACS+ on my AS5xxx for PPP dial-in. Can I use SecurID token as authenticatio...

Is there a way to setup a PIX 506 with a DHCP address for the outside (i.e. cable mode, DSL) AND also allow access to a web server or email server on the inside (protected/private) of the network? I have tried the Static and conduit commands to no av...

I have a PIX506 6.01 and would like to use it on my DSL but I only have 1 IP address and must connect w/ PPPoE. Is there a way to do this? Has anyone done it? My only alternative is to change service providers.

Does anyone know the current release date for PIX 6.0 software? The last I heard was the end of April.

With DNS I am trying to set up an permit statement for a node.any sugestions??

Hi,I want to setup a Linux server as a Syslog server for my PIX .The procedure which I followed does not seem to be working could anybody point where am I going wrong.I have created /var/log/pix/pixfirewall on the linux server & appropriately modifie...

Has anyone heard of any PIX simulation software or internet lab access to a PIX. I would like to try various configurations but cannot do it on our production firewall. Any links or suggestions appreciated.

i'd like to upgrade my pix 515 from 4.2 to 5.3 . How do i do that and how can i obtain an activation key. Thankx

I would like to know how do I ping or reach from my LAN to the external interface of the PIX or to my valid IP range of addresses.e.g If I need to expose a host on my internal network I would do a static mapping and then assign a conduit statement.bu...

I have heard that there is a new vulnerability in the IOS version 5.1.4 called the Origin Validation Error. I was wondering if this was correct? Also I run version 5.2.3 and have been told that to correct 5.1.4 I should upgrade to 5.3.1. Is 5.2.3 aff...

Hello,I have a PIX firewall between the ISP and our internal network. I am trying to access a web server internally. Now when my PIX's public interface is connected to the ISP, I can ping the internal web server from Internet but I can not access the...

Does anyone know what the license connection count is for the PIX 506?

I have a PIX 525 version 5.2. It came with the basic 2 ports and a 4 port card. The software can handle 8 ports. Can I add another 4 port card and just use 2 ports? Or, do I have to buy 2 single port eithernet cards? Thank you.

I can't pass netmeeting UDP (rtp/rtcp) traffic trough the PIX. I have tried with and without NAT, but only the Q931 channel works. Any idea?

Hello,I run Private Eye and have syslog level debug enabled on PIX.Problem: Due to accesslist on outside interface (deny any any) i get syslog entrys deny on backports for initiated from inside connections (higher ports)...thats okay so far ...but Pr...