Hi, Is snmp supported for FTDs in Azure ? cannot find any documentation saying that it is not. I am not able to make it work.Management ip is replying back on port 161 to snmp server but it is not working.
Forum Posts
Resolved! How to Block Youtube Whit Firepower?
Hello All I have this scenario can't Block YOUTUBE.and how doing block per network or users I try but don't work this form best regard. Sebastian. ,
Resolved! Issue selecting Tunnel Source
Hello, I have updated FMC and FTD to version 7.0.1 (build 84) and since then I have noticed that when creating a tunnel VTI the tunnel source does not provide all available interfaces. For example, in one of the cases I want to select outside interfa...
Hi,I am using Cisco Firepower2110 with Virtual FMC 6.3.2 version.I am facing an attached error while deploying policies. Could you please guide how can I resolve it.
Resolved! Restore a FMC backup on FDM
Hi,Today I have a Firepower FTD that are managed by a FMC. I want to set up another FTD, but with local FDM management, running the exact same configuration as the other FTD. Would it be possible to take a FMC config or device backup and then restor...
I have recently migrated an ASA5555-X context over to a standalone FPR1140 running FTD managed by a FMC.I used the FMT to migrate the objects, NAT & 500+ line ACL policy over which on the whole worked - there were some quirks that needed tweaking but...
Resolved! 5525-x 10 gig?
There is a listing for 5525-x ASA under product comatability for 10Gig module....I cannot find any documentation that shows the 5525-x support 10gig anything other then this listing. The spec sheet on the 5525-x don't come close to 10gig throughput e...
Hello! Does anyone know if it is possible to set up an email alert for when a user logs into an Anyconnect VPN session? Can this be configured on the FTD/FMC? Thanks
Hi Folks, Is it possible to configure the two factor authentication for the administrator in FMC or FTD without having DUO?
Hello everybody, our customer uses Firepower Service Modules in his 5516-X devices and miss the SNMP tab (see attached ScreenDump) in the FMC.That the Firepower Service Modules do not support SNMP can he understand at those are in the ASA5508-X but h...
Hi Community, How to get out TCP dump from Cisco ASA firewall. Spoiler (Highlight to read)ThanksAshokThanksAshok
Hi Team, I am looking for more information and eventually a recommendation on the following syslog alert. %ASA-3-209006: Fragment queue threshold exceeded, dropped UDP fragment from <source-ip> to <destination-ip> on Internet interface. There's quite...
Hi, I recently created a routed STS VPN against Azure, tunnel comes up but the traffic is being dropped when the communication starts at the side of the ASA, asp captures for traffic that should go trhough the tunnel shows the following messages ...
Hello, I'm deploying an FTD v6.6.5 created as native device in a Firepower 4110 appliance as replacement for an ASA5585 with Firepower Services, I have already added the FTD to the FMCv (v6.6.5) and migrated the ASA configuration using the Cisco Migr...
Resolved! Unable to add FTD into FMC
Hello, I am currently unable to add FTD into FMC, each attempt it comes out with error message host x.x.x.x is not reachable. - FMC in Europe, FTD in China.- The FMC ping successfully FTD and vice versa.- I did configure network management-data-inte...
