Network Security

Cisco SMA has rolled out a new GUI. Tried different browsers, systems, It's not working. I have attached screenshots. SMA and the client machine are in same network.Even telnet to port 4431 fails. Everything works when SMA is reverted to previous GUI...

Hello all I have done a previous deployment of Firepower but it has been years now so am rusty. I have a new customer that i'd consider small less than 100 employees that is under compliance initiative and their production network does not meet the r...

Hi  all, i was wondering if anyone could point me to a document containing the required information/prerequisites to upgrade my current ASA 5525-X firewalls to the newer Firepower releases.   The firewalls are covered by smart net contract until Apri...

I need to add about 80-90 hosts/objects into FirePOWER Management Center to build some IPS rules around them. Is there another alternative to add hosts, save for one at a time via the GUI?

So I set the following: debug crypto condition peer  10.10.10.1 debug crypto ikev2 protocol 127debug crypto ikev2 platform 127 However no debugs are displayed on the CLI for IPSEC tunnel negotiations. All configs for tunnel look good as it was workin...

Any word on when 6.7 will be supported for FMC virtual ?

With reference to the attached diagram, how will the traffic switch take place when the primary HSRP Switch fails.What will be the traffic flow direction in such a scenario.. If the Firewall is monitoring PortChannel 2 for failures so in case Primary...

Hi There, I have cisco asa 5505 firewall configured as per configuration I am able to access internet.Also I configured ssl vpn but I am not able access my internal network after connection.Please help anyone to sort out this.I am not getting what I ...

Hi all, I have an FTD 6.3 on Firepower 4110.  It is configured in routed mode with "the usual" configuration: outside, inside, DMZ, and serverfarm interfaces/zones with traffic allowed out but not in. I also have AnyConnect services for remote access...

I want to keep track of the change in ACL in ASA by using TACACS+ accounting, by determining the user, command, time,...    I have the following command in ASA:   aaa-server ********* protocol tacacs+ aaa-server ********* (inside) host x.x.x.x aaa-se...

Hello,I have a situation with an ASA 5508-X where I cannot get any traffic to pass through on anything other than it's own IP address on the outside interface. To clarify, the outside interface has a /28 on say 1.2.3.34/28. Traffic passes through for...