Optics and Optical Networking

HiDoes anyone know when they will release ONS 15454 5.0 software. There are a lot off issues solved in version 5.0 but i can't find when release 5.0 will be available.Kind regards,Maarten Vervoornhttp://www.okena.com/en/US/products/hw/optical/ps2006/...

i tring to connect convertar OVISLINK MC1000TSC ( 1000 base-t to 1000 base-sx multi-mode(mmf) with sc connector to a cisco switch( catalyst 2950c-24) but it doesn't work.so anyone has any information about that it would be nice to help me with it.

I am a new to MetroPlanner.I would like to convert ROADM traffic to present traffic and make sure the successful analysis using upgrade function. I would like to know how to force certain installation parameters.

Hi,Is is possible to have dwdm connectivity on the 3750 series switches ?The only wdm sfp connector available for the 3750 is CWDM.I was told that all you need is a Fiber GE connection on the Switch.Any advice appreciated.Thanks,Paul

2-port OC-48c POS SM Model OSM-2OC48/1DPT-SS is automatically being powered down with IOS 12.2(33)SXH1 on a CAT 6509-E, but comes up fine with older version 12.2(18)SXF6. I couldn't find any known bugs, but maybe I missed it somewhere. Any help would...

What is the TL1 command used to extract the time taken for a optical signal to switch to "protect" mode? I am specifically in need of getting down to the Millisecond range. I found:service timestanps debug uptimeservice timestanps log datetime msec...

Hello everybody,I experience an increasing number of SDH NSE + NEWPTR events, about 40 event/second.I have a 7200 VXR router with a PA-POS-1OC3 card (STM-1), connected through an SDH network to another router. Both routers clock source are set to "li...

Hi guys,I do install a CTM 8.0, and i try to add NE ONS, but it can not recognize it, the error was "AUD-2500: Transport Manager was unable to initialize NE : 172.29.1.108 because 05.02-005C-26.23 is not supported" as far i know and read in Cisco, th...

Hi Friends, The POS SPA for 7600 SPA-2XOC3-POS says that 1+1 APS protection is supported.Would like to know the implementation, is it per SPA (2 ports in the same SPA) or divided across different SPA ports.ThanksCheers,~sultan

Hi Friends,Wanted to know if anyone here has implemented channelized services on this SPA module SPA-1XCHSTM1/OC3 (or any other similar one).My setup is that I will be taking STM-1 ports from an overseas provider connecting it to my ADM (Alcatel), o...