Other Data Center Subjects

Hello All,I work in a Data Center/SP in California. My management has recently been told that using RFC1918 addressing rather than public registered addressing will provide security/meet "best practices". We own several class B networks and have plen...

I am trying to configure VE port between Cisco nexus 7K and 5K switches but the vfc is not operational as VSAN isolation. I have bind the VSAN 100 to VLAN 100 and add vfc into vsan database, but the VSAN 100 is still operational down                 ...

Hello,I am new to nexus world so I'm  reading a lot of documents regarding nexus design and guidelines.I should propose and implement a Nexus solution in a server farm/campus currently made of catalys switches(6500).THe topology is made of two core 6...

I have never touched a Cisco Nexus. I am holding an CCIP and I am thinking about converting into an CCNP Service Provider. What do you think is the best way to start with the Nexus series?---Posted by WebUser Marcel Paries from Cisco Support Communi...

I want to know if I have pair of Cisco 4500X that form VSS and each of 4500X has 1 link to one of the N7K.Is it similar with a Server(pair of 4500X with VSS) using vPC to the N7K?What is the mac-address learning behaviour?         

Recently purchased 2 Nexus 7009 Chassis for our datacenter. We are wanting to mount side by side in two post racks. Is this a supported mounting config since the 7009 uses side to side airflow. The clearance between the chassis is approximately 7 inc...

Can we use ACL or routemap to control/block the packets which is going to the control plane or management plane of ASR 9000 routers and how is it possible ?

Can I have two core nexus 7ks connected to a single catalyst 6509 (Sup720) using vPC?

With Naman LatifWelcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about different solutions and best practices around securing your physical and virtual environment in the Data Cente...

IS there any VXLAN offload NICS available in the market?

Hi,I have 1 NX5K & 1 NX2K (FEX) and configured PIM on them -Release 5.2(1)N1(1).I configured on the NX2K's ports the ip igmp join-group command to statically bind a multicast group to an interface. The multicast PIM works fine but when I try to remov...