Other Data Center Subjects

HelloTwo questions.1.I am migrating a traditional Ethernet to ACI, in this fisrt step we will connect VMware bere metal host.Accordinlgy to the documentation ACI can Integrate with VMware with VMdomian, but in this phase We dont need this configurati...

Hi,I have an issue about HSRP isolation (active/active) between two datacenter. Datacenter12 x Nexus 7000vPC domain 1 Portchannel 3 (vPC) to datacenter 2 (Nexus 5000)Datacenter22 x Nexus 5000 with L3 cardvPC domain 2 Portchannel 3 (vPC) to datacenter...

Hello allI try to perform a shutdown in the physical interface via xml.But appear the error Invalid access, MO: l1PhysIfChecking the information the physical interfaces (l1PhysIf) needs a different config as the other objects.<?xml version="1.0" enco...

Hi everybodyI've a question.Is possible configure a type Mac Sticky on the LEAF's ports ?Because, I'm searching but only found is bandwidth configuration on portAnd in the documentation shows "static endpoint" but when configuring the MAC and conect ...

hello,So i have the following scenario: Primary Data Center:2 Spines and 4 leafSecondary Data center:1 spine and 2 leaf. Am trying to do a Vxlan Multi-site.i have a SP link with and l3vpn that give me comunication from site to site,so i wanted to kno...

Does anyone know the procedure how to remove a Windows binary installed DCNM server from a federation?

Greetings!We have two Nexus 5020s, running ver. 5.0(3)N1(1b), with Nexus 2148T Fabric Extenders attached.  I have noticed that on all active N5020 interfaces, as well as some of the 2148T interfaces, the jumbo packets counters are incrementing.  Howe...

Hi - In reading the Cisco documentation on the best practices for OTV implementation [1], I am unable to determine if FHRP isolation can be applied per-VLAN or not.  While I understand the vACL and ARP inspection commands prevent the HSRP packets fro...

Hi, I am preparing for the CCIE DC v2.1, I have covered the theory, looking to practice on rack rentals. INE workbook is for CCIE Dc v2 not 2.1 and its just beta version, it has little to no details for ACI. IP Expert are gone. Really struggling to f...

I'm looking to upgrade from 4.2.4 to 5.1.5 and after running the impact command got the following message:show install all impact kickstart bootflash:///n7000-s1-kickstart.5.1.5.bin system bootflash:///n7000-s1-dk9.5.1.5.binPre-Upgrade check failed. ...

We have two n9K-c9508 Switches that we are installing in our Data Centre. They will be connected to two power rails in each cabinet that are supplied from two different distribution boards. Currently I have some spare single phase power rails and we ...