Other Network Architecture Subjects

hi guys,im having some problems with my inbound traffic. im using a single router with my own as to connect to my 2 different providers.my providerA has 4Mbps and my providerB has 8Mbps of bandwidth. my problem is most of my traffic are going in prov...

I have 2 17xx routers with a T-1 dedicated link between them in service. These routers also have DSL WIC cards with DSL service from BellSouth. I would like to create a VPN tunnel between the two units to use as a backup route when the T-1 Dedicated...

Hello folks;I have 4 BGP sessions to different providers, in several places of my network. The providers are sending me full BGP table, however I have some filters in place to only get several networks (the ones from my country) into BGP table. The I...

I'm trying to configure two Pix endpoints so that "Site A" routes to an external IP defined on "Site B". The networks are connected via VPN site-to-site config'ed via the Pix'es.Is this possible, if so - configuration highlights would be very helpful...

HiI have Pix515 between 2 Routers ,and local Ftp server ( 129.168.2.2) attached to pix (dmz zone).lntern Clients back r2 are able to access to my ftp server in the dmz zone. I have only one ip address address 80.x.x.16 ( ISP ip ) in Extern router ( ...

Need to identify which ports are participating in an etherchannel on a 6500 switch running catos

HiIve been trouble shooting some network problems and Ive noticed something strange. We have 2 6500s as the core of our network both have interfaces on vlan 1. When i ping one 6500 say "6500_A" the replies come back with a TTL of 59. But if I ping th...

how could i config in it My network have had internet connection in range 192.168.0.x/24 and gate way:192.168.0.10, DNS: 203.223.32.3

I am researching frame relay for our organization and am a little confused by VPN methods. What is the difference between establishing a VPN connection at layer 2 versus layer 3?

We're configuring port E0 with an internal and external ip - the models we've seen have the public ip as secondary. Is there any importance to that set up?

I'm having problems with a Catalyst 2950 48-port switch with the standard image and auto-negotiation. It takes about 30 seconds for the clients and the switch to successfully auto-negotiate a connection. Has anyone else seen this problem?

I have a catalyst 7609 with 12.2(18)SXD3 IOS verion .Recently , I got a error message in log server , below：01:37:54: %SYS-2-MALLOCFAIL: Memory allocation of 65536 bytes failed from 0x601597F8, alignment 16Pool: Processor Free: 26616 Cause: Not eno...

I'm trying to configure static nat in this way:fa0/0 - 192.103.83.100 - nat outsidefa0/1 - 192.168.40.254 - nat insideI need to access ip 192.168.40.100 from outside to inside using a different ip address, so i configuredip nat inside source static 1...

Hi,does anyone know why my catalyst 6509 is stripping the dscp information out of the ip header. Setup is as follows: Alcatel IP phones connected to on of eight 4507s floor switches which are connected to a pair of 6509s running ospf on the uplinks.M...