Other Network Architecture Subjects

I have a Cisco 2621 router connected to a PIX 515 firewall. The computers connected to the firewall can ping the port on the router that the firewall is connected to, but cant go beyond that. Here are my configs:Router (Cisco 2621)!username xxxx pass...

Hi AllI have got my laptop Dell Latitiude D600,,Pentuim M, it comes with built in wireless card and Normal ethernet card,,I can access internet via built in wireless card with no problem,,,If I want to use my laptop as normal workstation in the cisco...

I recently joined in a company. I have cisco 4500 router behind the firewall connected to CSU/DSU. I have local users are on the private network 192.168.79.0. Public address assigned on the ethernet0, ethernet1 and ethernet2. Static route is assigned...

I have to configure a couple of cisco 2621xm. One must be connected to a primary link and the second one to 4 isdn lines for backup of the primary one.Ospf will be used as routing protocol and I have to configure hsrp too (and also a backdoor access ...

Hiya,im trying to use the software advisior to check release for my catalsyt and it comes up with erros about the different modules. I won't allow me to specify the modules in my Cat 6006 ?? Is it currently faulty ??ThanksEd

Hi all,Sometimes, i have some critical error on our Cisco Router. Now, we are using Cisco Router 7609 and IOS c6msfc2-psv-mz.121-19.E1.bin and boot image: c6msfc2-boot-mz.121-19.E1.bin.Critical errors was describle below:2005-01-10 00:17:38 Syslog.Er...

Our company is moving its production site from one physical location to another. In order to do that, part of the site will be physically moved to the new location, the new site brought up with a skeleton network, the old site shut down and the bala...

I have a customer that has a bunch of Cat2950G's and was using non-Cisco GBICs for connections between them and some Cat6500's. They tell me that starting with releases after 12.1(6) they can no longer use non-Cisco GBICs. They believe that someone...

Hi, This is a strange kinda question and has nothing to do with a good design but anyway. Does anybody know if there is a way of allowing the same vlan id on multiple sub interfaces on a trunk? Ie: interface fast 0/0.1 encap isl 10 ip vrf forwarding ...

Hi All,when reloading a c4500 router with the following cmd, Router(boot)>enRouter(boot)#reloadProceed with reload? [confirm]it goes to rommon 1 > mode. Please see below for full output. I had successfully erased the nvram data just prior to what is ...

hii have a central location and 3 branches, e1 link is there in all branches no data traffic.i want to enable video conference using video conference unit.so for this for central site i can keep 2691 router is it? with VWIC-2MFT-E1 and for branch off...

I have erased IOS from 3661 router and it was reloaded. Now I have rooman prompt. How can I install IOS on this router?kindly let me know