Did ASR 1000 support icmp latency monitoring?how do i monitor the total latency(RTD) by week/ month? my job is to measure total RTD/latency (mark yellow in the attachment) from my router to ISP(mark blue). For example i sent ping request to my ISP t...
Hi,I have three interfaces: Inside, DMZ, Outside.Inside has a wireless router (using 10.0.0.2) to connect to ASA (10.0.0.1) -using vlan 1.DMZ (vlan12) is setup with 172.16.0.1/24 ~ I have 3 servers (.2 -.3 -and .101....the 101 is an ubuntu (12.04) se...
I am building a home lab. I have a 1841 router connected to the ISP router and is configured and works good. I have 3550 switch inside my network. I can ping as far as the outside interface on the router, but not further then that. No idea why. I hav...
We want to connect another companys 887 router into a 888 via the switch ports on both as we can apply our own HSRP, PBR and ACL policies to it. Will it do layer 3 via the switch ports. if i connect them together then i can forward to the lan layer ...
Hello All,I have a Cisco 2900 series that just blocks traffic in and of it. When this happens, i won't be able to log into it nor ping it locally using its local IP or Publicly using it public IP. But when i do a turn it off and on again everything b...
Please tell me why the secondary in my vPC pair of Nexus 5k's give this failure error and the primary shows no connection errors at all:sh vpcLegend: (*) - local vPC is down, forwarding via vPC peer-linkvPC domain id ...
Hi experts.I have recently deployed ISE with machine authentication. However, when the machine is already plugged in to the switch before booting, the machine does not authenticate automatically. It isn't until I log on, using a local computer accoun...
I need to configure subinterfaces on the following devices Cisco 800 and Catalyst 2960, but when I am trying to configure it on the router, it gives the following mistakes:router (config)# int fa0.100Invalid input detected. What's wrong?
I'd like to login ASR9001 using ssh RSA public key authentication.
So I tried to import ssh key but the command in the manual didn't work.
I've referred http://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r4-3/security/configuration/g...
sir i would like to know the configuration commands for sfp port to become trunk,,,is normal trunk commands are enough??or any special commands required
Following router/IOS/WAN upgrade OSPF is not advertising the subnet associated with the Loopback interface. It does however advertise the actual Loopback interface address. The subnet associated with the Loopback interface is used for NAT translation...
We are currently using Cisco VPN Client for Windows 7 connecting to Cisco ASR 1000 and Cisco 3925 Routers. To start using Cisco AnyConnect Client with existing Routers:-1. Will the client still work with Router IOS ?2. What additional configuration ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
.jpg "VIP Community Legend"){kind=icon}
.jpg "Hall of Fame Master"){kind=icon}
