Other Network Architecture Subjects

Hi,I noted the following on one of the modules in a cisco 5000, the question is are all the vlans allowed or is only one vlan allowed accross the ports:set vlan 1 2/1-8,2/10-12set vlan 104 2/9set trunk 2/1 on isl 1-1005set trunk 2/2 on isl 1-10...

Hi If the dialer idle-timeout is not set, what is the default timeoute?

We have a Cisco 6500 and we are going to install a new blade WS-X6548-GE-TX (10/100/1000 RJ45). The CatOS version for the SUP2-2GE is 6.3(6). What level of CatOS do you suggest? I check the CCO and looks like they have CatOS 8.1, is that good?Thanks,...

I have downloaded some IOS due to the recently IP v4 problem. Can somebody show me a step by step on how to upgrade the current routers/switches IOSregards

I have an issue with OSPF. We have an area 0 and 1 and 2. 1 and 2 both connect to 0 via tunnels. Since 1 and 2 both connect to the backbone this is fine at the moment, but we are being pushed to put a wireless link between 1 and 2 to pass a portio...

The problem is between a PDA , and the 2600 integrated modems ( 8-NM module ). The PDA is calling a PSTN number of 2600 integrated modem connected to the pstn, the router is configured to work as an X25 PAD so when the PDA is supposed to co...

Is anyone aware of any other companies that make GBIC modules. Are these recognized by Cisco? I know that Cisco GBIC's are around $500.00. All suggestions are appreciated.

Dear,Are you sure that third party GBICs are not supported in the series of Catalyst 3750?what shall we do then the third party GBICs can be supported in these new switches.I heard that Cisco coded his switch via EPROM,Cisco's switches is too expensi...

I have two sites Phoenix & Newberlin each having one IGX & Router. We have the T3 between the Routers. However between IGXs at Phoenix & Newberlin we are having only 2x T1s. Is there a work around such that I can connect my IGXs at Phoenix & newberli...

Does ciscoworks2000 support Chinese language platform,for example Solaris 8 Chinese Simplied Language edition?

Clean install of RTM on a new W2K server.nGenius Server - Switch tab, Device - Add Switch from menu.Add my 6513 switch ( which has a NAM in slot 07 )Task Progress reports SuccessAdding Switch:6513 reports Adding 6513 - All OK Adding NAM - Al...

Is there a way to view the amount of traffic that has transversed an interface? in either kb/mb/gb? the only option I see is 'show ip traffic'...

I currently have an AS5300 Cisco router for my E1R2 dialup connections. My problem is, some of my dialup users have difficulty in establishing connection due to these errors: Line User Host(s) Idle Location 2 tty 2 ...