Other Network Architecture Subjects

Hi,I have citrix server farm situated in my VLAN 1 and my backends servers on VLAN 2. I need to generate some reports on the traffic pattern between the Citrix servers and the backend servers. The reports should have details of bandwidth utilization...

How do I force a 2513 into ROMMOn mode ??

Hello all, When i am seeing debug of bgp updates and events, i got "recursion error routing loop" for one ip address say 172.16.1.1/30. I am having two providers, say A & B. With B, asymmetric TX and RX circuits. The IP ad...

Hello everyone,Out of the 80 something switches in the farm there are a couple that log an error message that reads: " time-switch name-GigabitEthernet0/2 relearning 11 addrs per min 1." This is the topoly: 3500XL connected to 6513 (core router) via ...

Ok, sorry for the Newbieness of this question, but here's the situation:I've got a 2600 series router; it has two ethernet ports and a WIC with two T1 ports.I need a walk through for getting a basic configuration put on it just to make sure connectiv...

I'd like to use ip accounting to do some simple bandwidth tracking. I want to specify address ranges within our LAN and track the number of bytes to/from those ranges. I don't care about the IP at the other end of their connections. All of the addres...

A "show cam dy x/y" lists many (about 40) different vlans with 00-00-00-00-00-00 MAC addresses. I am running 5.5(18) on a Sup2g with vtp. The ports are assigned to vlan52 (which is correct). MAC addresses on vlan52 are valid and vlan52 is part of ...

Here is the diagram ----------------------------- | | | frame-relay || cloud | | with RIP |================...

Our current setup, which is being used until I get the new hardware working, is such that we have two routers with the internal router providing NAT and static routes to specific inside servers such as the web server and the mail server. No DMZ, jus...

I am running a Cisco 1605R as a VPN Client. The 1605R is running 12.2.8T4 IOS with IPSec. We are using this in a Router to Router VPN to a remote office. We can only get Cable Modem Access to this site and have been using the DHCP feature to get the ...

CISCO 2522. I want to use a analog modem connect to Async port.and use terminal callin and then autotelnet to a SCO system. is it possible?and what shall I do to config the router ?thanks.

Some devices are showing INCORRECT in the Telnet and TACACS entries. CLI telnet to these devices works fine using TACACS login. Only a small portion of devices have this problem.

We´re planning to set up backup WAN lines for about 300 remote sites. We're going to use ISDN BRI (only 1 B-channel used) at remote sites and one PRI in our central site (maximum 30 backup links at one moment). Central site will start ISDN calls (out...