Other Network Architecture Subjects

Has anyone seen this error before? Telnet: PGM_NM=Configuration Archive:6737:TYPE=unassigned message type::Failed to initiate telnet session, Cannot telnet to U152876_172_31_51_32 RCP: PGM_NM=Configuration Archive:6761:TYPE=unassigned message type::P...

Hello,I have a catalyst 355012T, i try to have an access to my switch whith a serial port (COM1) and i don't arrive to it .I set my emulation speed to 9600 baud.THANKS

Anyone please help to clarify my queries below;(1) I were to use a channelized PRI line with 30 channels on my 3620 router, how do I configure the number of PRI channels that should be occupied by each remote dial in office ?(2) For the 30 PRI channe...

IHello,I have a catalyst 3550 12T and i just want tio initialize it, so i want to clear all my entry.I have already try the commanr "reload" but il take my last save of the file "startup-config", So i want a complete initialisation of my switch THANK...

Is there any command that shows me the clockrate/Speed of my Leased Line.A "Show Controllers S0" for example just shows me that there is RX and TX Clock detected, but not the Clockrate.RegardsWerner

I have a connection at one of my branches that is experiencing packet loss in the 10% range. I have been doing some ping tests and have noticed something strange. When i ping from within the network to anywhere outside the network i get a reply from ...

FASTBOOT is invoked by setting configuration register bit 4; What exactly does this do ie. what is FASTBOOT?

I'd like to install nGenius on a seperate server as the doc suggests. It appears it is unnecessary to install CD1 of Ciscoworks to do this. My question is, should I install Ciscoworks CD1 and then nGenius? and if so, why does it benefit me by doing...

Hi Buddy,In my network , configured 20 VLAN's. 2500 users are configured. is there any limitation of usre's per VLAN. how much user's we can configure in per VLAN.Thanks & Regards,Ciscobuddy

Hi freinds, We have 3 subnets in our office, Configured as secondary Interfaces on the Router. Our Servers are spread across these 3 subnets. Say if I block a port on server sitting in Subnet A through access list, and run a po...

I have eight 3548's that I'd like to daisy chan together via the GBIC ports. I'd like to know what is the maximum number of 3548's you can daisy chain together via the GBIC ports. I've been told that two is the max and anything after that causes pro...

What will happen with the incoming and outgoing calls when I configure the following:Case 1:interface BRI0encapsulation ppp dialer pool-member 10 min-link 1 max-link 1! interface Dialer10encapsulation ppp dialer pool 10Outgoing calls:By min-link 1 co...

Hi alli am trying to put an analysis for a customer of mine on High availability.....i need links to a paper that explains the standard terminology on calculating the '4 x 9s".....similar to MTBF/(MTBF+MTTR)...but more interested in how you correlate...

Hello I have a Supervisor2 with MSCF2 running on native IOS. How do I revert back to hybride OS. Is there a document with the procedure? I coulden't find one on the CCO.

Hi AllMy customer is running IOS ver 12.2 on his 2620 for Internet Connection with WIC-2T installed. The ISP has given them 2Mbps leased line. The following has configured on the serial interface:interface Serial0/0 bandwidth 2048 ip address 210.187....