Other Network Architecture Subjects

I need information on the new 4506 switch as it relates to power comsumption. I have 2 questions.I need a power source to connect a wireless AP1200, both radios without using a Power Injector. Can the new 4506 be used to power a quantity of 17 AP12...

Is there any IOS commands in Catalyst 6509, 3550 and 3524 switches where the Serial numbers can be shown. If there is then it will save me a trip.Thanks

I have a 3620 w/ a T1 PRI to 24 mica digital modems. If i call the number, i get a fast-tone busy signal. Only fastethernet, serial1/0:23, Dial0 and Loopback0 are up, whereas Serial1/0:0-22, Group-Async1, Async1-24 are down.Attached is the config, i...

I set up a port channel for 1/1-2 and 2/1-2 but in my config I see a port channel 3/1-4. It's really wierd, because I blanked out the switch and reconfigured it from scratch and then the 3/1-4 just re-appeard there in the config. Does anyone no how...

OK here is the deal,I have the following configurationCisco 1721 - #1f0 - 192.168.0.10s0 - 192.168.1.1Cisco 1721 - #2f0 - 192.168.3.11s0 - 192.168.1.2From either ethernet network, I am able to telent into it's respective router. From there I can tel...

We are preparing to install CiscoWorks LMS and I need to clarify certain system requirements:1. The spec sheet says Windows 2000 SP2 is required. Is Windows XP professional an option or has this not been tested and/or approved?2. It specifies 1-GB R...

I would like to use a serial port for network management : I need to connect the PC to the router through one serial port(com of the PC) adn the second com with the radio part.I know that console serial ports are used for router management. So cons...

Hi I need to use full duplex in an Ethernet Interface of a 3620 RouterDo I need to use any specific IOS for this?Thanks

Hi,I have two switches connected by a trunk. How can I understand how many traffic is from/for a specific vlan?Thanks.

Hi, We are using DSL 677 for internet connectivity. I am tring to use MRTG for tracking bandwidth of this dsl link. which MIB can I used to track for perticuller Ioutgoing interface bandwidth. Also I will appriciate if you provide me the configurati...

HiIs the Netflow captures one way traffic. For example if i need to capture trafficfrom a host connected to a flow enabled router can this capture both way traffic?The problem is when we fix a equipment (packeteer) to the same network and monitor the...

I'm new to setting up VPN/Dial-in Access- can anyone give me a basic configuration that will let my remote users log into our network through the built-in modems in our router/log in through a VPN tunnel? Any help will be greatly appreciated.Thanks a...

Hello,3550 has got lot of collisions on ports.3,4 ports have got this message :Error Message ETHCNTR-3-HALF_DUX_COLISION_EXCEED_THRESHOLD: Collision at [chars] exceed threshold. Consider as loop-back.like show on this url http://www.cisco.com/en/US...