Other Network Architecture Subjects

My company is looking to build a solution that would be used in large venues and events such as stadiums with massive amounts of people/devices (around 80,000 people/devices assuming all seats were filled). Right now we have targeted the 6504-E with ...

Hi,I have at the 6500 with vs-s720-10G. the datasheet say 1024 VRFs each populated with up to 700 routes/VRF for MPLS. MPLS in hardware to enable use of layer 3 VPNs and EoMPLS tunneling. Up to 1024 VRFs with a total of up to 256,000 routes per syste...

Thanks for help in advance. I have a fiber 10mb connection delivered as Ethernet. I have a 2811, (1) HWIC -1FE and (1) HWIC -4ESW. I would like to know which module I should use and configuration example. Also, my ISP gave me serials and my LAN block...

Hi thereAnybody knows if License LIC-CT5508-5A will be available soon?Cisco Configurator tool shows an NPH until Aug 15Regards

I am classifying traffic using NBAR and Access-lists, setting DSCP values, and then useing bandwidth percentages to reserve bandwidth for protected classes in times of high utilization.I currently have this setup on my outside interface (connecting t...

hi,we have an  cisco uBR7246VXR (UBR7200-NPE-G1) with IOS ubr7200-ik9su2-mz.123-23.BC7.bin.Cisco doc says: GIADDR Field When using separate IP address pools for cable modems and CPE devices, you can use the cable dhcp-giaddr policy command  to spe...

While I was working in this program, I found a pretty bad thing. When I configure the tunnel destination (on Router 1) and choose ip address appointed to the remote (Router 2) sub-interface (for example fa0/0.10) but not physical interface (fa0/0), t...

Hi,I applied command "auto qos voip trust" to the uplink interface. But I found that the interface shown command "auto qos trust" was applied when i show running-config.Could the command "auto qos voip trust" show in the configuration after i applied...

Hi,Want to know how can we stop topology change notification from specific network switch connected (Switch-Switch) over trunk port?I used the spanning tree portfast trunk command but its still show me in sh spanning  details as topology has changedI...

I am trying to put QOS on my 6500 trunk port using MQC however I keep getting an error.  Basically I want to match a VLAN and allocate a minumum 100Mbps on that interface, with the ability to use the entire gigabit link if no other traffic is travers...

Hi all,I've been configuring Catalyst 29xx as access switches for quite a while. I noticed that the patchpanel numbering and the catalyst ports numbering are not corresponding in their progression.The Catalyst ports are numbered top to bottom and lef...

                   Is putty the only program that configs routers ?