Hello,I have an AS5300 with this version :IOS (tm) 5300 Software (C5300-I-M), Version 12.2(1c), RELEASE SOFTWARE(fc1)Can I use NetFlow features in proper condition ?Best regards,Sorin PARLOG
Wanted to know if any one had sample config for setting up PPP Mulltilink on Channelized DS3 using PA-MC-T3 and 7507 on one end and 7204 on the other end. Thanks in Advance!
I am trying to configure HSRP with ACL's Box: 2 x 6009 with MSFCMultiple Vlans with HSRP (works without ACL)Issue: e.g Extended ip address list <xxx> permit ip<subnet> host 224.0.0.2 (Matches) Ex...
I have a number of 2950-24 switches at Version 12.0(5.3)WC(1) which reboot roughly at the same time each day. Being distributed over a WAN, this points to the Cisco Works polling as the initiator.Does anyone have a solution to this?
i would like to know how to disable the write-protect on the pcmcia card in 1603 router.When I tried to copy new IOS to flash fron TFTP it says "PCMCIA card is write protected,cannot erase". But I was able to copy old IOS from flash to TFTP. The flas...
Hello,I checked the doc and it seems that the Cat3550 doesn't support private VLANs like the Cat6500, but there is another feature called protected ports. Can someone confirm me tthis?Thanks in advance.Rui
Hey Group,How do you go about determining what the pps rating really means? I normally have just 'shotgun' designed small router configs based on the number and type of interfaces I needed, but I'd really like to know of a somewhat more scientific m...
I have gotten the error-message "%SYS-3-EOBC_CHANNELREINIT:Ethernet out of band channel reinitialized (1)" once on a 6509 with dual sup2 running version 6.3(8)Tried to look at the system message guide documentation, but it's not included there.Does a...
I have EIGRP configured between two routers. routers are connected with leased line. both have configured loopback interface. but loopback addresses are not propagated into EIGRP - all other works fine.I do not see them in:#sh ip route#sh ip eigrp to...
Hello All,I am in search of a critical answer. The 6513 has two possible power supplies a 2500W and 4000W. The cisco document on the web states that you must use 220 power to have the capacity of 2500W. They also state that a fully populated 6513 ...
I'm looking at getting a VPN over Internet to Sweden from Tokyo soon. For backup purposes we will have dial on demand ISDN on Cisco 2600 series router.Can I configure HSRP or on the dialer to not dial during certain hours to save money? It's pretty u...
We had an isolated network (10.1.x.x-10.5.x.x) in a remote location for a period of time. Over the last year we installed a T-1 that provides us (our main office (192.168.x.x)) connectivity to that isolated site. The setup was configured as follows...
Haloo networkers,Is it posible to configure a priority based on a single host? Lets say a host with IP 10.0.0.1/24 will have high priority when travel the WAN link compared with others user in the same network? Give some sample link/config please. I ...
