We recently upgraded from 8 lines to 23 on our PRI, and want to confirm that the telco has indeed added the lines. We have the PRI line into a Cisco 3640 router.
A 3640 router with 1 ethernet if and 8 ISDN-BRI interfaces is used for remote access (dial-in).For redundancy reasons a second router is installed in parallel (all ISDN lines connected to both routers). In order to avoid changes in the rest of the ne...
We have a Cisco 1720 with two WIC:1 x ISDN1 x ADSLHow do we configure the router to achieve the following:The ADSL link should be the primary Internet connection. If the ADSL link fails traffic should be sent through the ISDN line (permanent).The pro...
Is it possible to configure Class Based Weighted Fair Queuing (CBWFQ) on a dialer interface of a Cisco 803 router to give priority to a certain important application ?You can configure CBWFQ (IOS 12.2(8)T) but the show policy-map interface command co...
We are adding a second T1 to our central Location. how do I configure the 2650 for the additional channels ?The telco is adding channels for second T1 to increase bandwidth to 3mb.
I have two ip addresses like 172.20.18.246,10.1.125.3.Router has one bri port dialing two ISP's so I have configured two dialer interfaces.I need to allow all Internal users(192.168.0.0) to access both ISP's.I have put ip nat outside command on both ...
I have a problem with remote connection. The access-list set in cisco-secure is used with a pstn connection but not with a isdn connection. I have this message PERUSER-3-ISDNINTF: Se1/0:18 access_group: Can not apply configuration to ISDN channel: t...
I have Central site with one ISDN (2B+D) Circuit. I have two remote site one with ISDN and other with Centrex 56K Data Circuit. Following is configuration of Central Site and one of the remote site with Centrex Data. Why can't they connect to each ot...
we want to use two Quad E1/PRI into one AS5300. the software is IOS Version 12.0 (7). the first one is build in slot 0 and we want to put in the second one in Slot 2. the slot 1 is occupied by Mica-Modems.at the reboot after the build up we see the ...
I am configuring an ISDN dialer backup, all works ok with the following static routeIp route 0.0.0.0 0.0.0.0 172.16.40.5But will not work with the following static routeIp route 0.0.0.0 0.0.0.0 bri0I get do a debug ip packet and get an encapsulation ...
We are using virtual-profiles to assign access-lists via radius on a ISDN RAS connection.We set the session idle-timer to 300.When the connection is established I see two Timer ( "sh user" virtual-interface and serial-interface). When traffic is send...
I want to I-mux 6 Serial T-1's using a Cisco router. The web page is not clear on router requirments. Some links say only a 7500 with certian VIPs support the feature, but other docs picture 7200's. Will a 7206VXR with either and NPE300 or NPE400 I-M...
