Users are dialing in to a 3600 and get a dynamic IP from a pool. DNS info is hard coded at each client and needs to stay that way. A client hard coded their host IP address as the DNS address by mistake and DNS was down during their session. Not ...
I am using a Router 3640 to do remote access. This router make authentication against an ACS 3.0.I need the clients to get the IP from a pool specified in the ACS.How can I do this?
I have 2 x 2611 with 4 port ISDN modules.I wish to use them to connect two sites using 2 x ISDN-2 lines and keep the call charges at one site by using the dialer callback feature. Site A will be with callback and site B without callback. It is intend...
where should I look 1st? Setup: IP Voice Server and phones in remote office connecting to 2950, 2950 connects to 2620, 2620 has (6) 64k channels to 7206 and central site. Need to reserve 192k on the WAN for 3 call max. 7206 connects over sw. Eth. to...
I would like to hookup 2 routers via the serial ports. I know one needs to be DCE and the other needs to be DTE. They are both 2500 series routers. Where do I get a cable that will go between them (DB60 on both ends)
I'm trying to move a 530 serial interface from a Fast serial Interface processor an a 7500 router to a cisco 4500 router. when I move the cable the 4000's interface shows UP / UP, but does not respond to a ping. All the controll leads are showing up....
I have a problem assigning default gateway to the client who connect to my router.Now I have a router 3640 with Cisco IOS 12.2. An ACS 3.0 to which I authenticate.How could I define a default gateway to the clients?And how I could define a domain nam...
I have analog and ISDN users dialing into a 3640 with PRI ISDN and DMM's. I authentcate with RSA ACE Server and Authorise with Cisco ACS. All analog users are set up for roaming dial-back. This works fine unless a user decides not to use dial-back an...
We have a network of IBM routers linked via Frame Relay in a Hub/Spoke scenario. The branch routers dial into the central site router via ISDN if the primary frame relay link goes down.We are now installing new Cisco routers for new branches and have...
I can establish a ISDN call from South Africa to Sweden but not from Sweden.I have found that my layer 2 is TEI_ASSIGNED AND NOT MULTIPLE_FRAME_ESTABLISHED This is my configuration on the Sweden 1750 router.Front#wr tBuilding configuration...Current ...
I want to know how I can confirm that router serial ports are working (100% sure) with using DTE-DCE back to back cable for e.g Router is 2501.I can check LAN port easily but how to check serial ports as I do not have DTE-DCE back to back cable.
I have a headend router with 6 serial interfaces. I want to turn on frame-relay keepalives configuration on just ONE of the interfaces. Is this possible and if so how do I do it?
