Other Network Architecture Subjects

I have a router 3640 and i need a capacity grater than 8 Mbps, i have this router with 2 modules NM-2W with 2 WIC-2T, so I have 8 serial interfaces.Can i have 8 Mbps in one of this module?Why if i connect this 4 serial interface i can pass 7 Mbps o t...

Can someone please give me some hints on ip route optimisation accross wan linksthanks in advance

I would like to know if a switch port of a Catalyst 6506 can belong to 2 or more vlan at the same time whitout be a trunk port.Thanks

I have a primary link to one router with a set of static NAT translations and I have a backup link to another with the same translations. If I take down the primary links, routing directs traffic through to the backup link but I seem to lose the stat...

After requesting and talking about "Class A" tests a bazillion times, I thought it might nice to know - specifically - what it is. Can anyone technically define what the test is, how it's run, what it looks for, and/or clarify what the results will l...

Ok i have a question for all you cisco experts out there. I am kinda new at the whole router thing. We had a site's T1 line that goes into a 2621 become in a looped state when we came in in the morning. When we called for maintainence on the circuit ...

Gurus of all things Cisco...I want to set up an ACL that denys inbound traceroute both to my router and internal networks. I know that on some Unix and Linux operating systems, traceroute uses UDP packets to causes routers along the path to generate...

Quick question....I have a scenario where I have a primary DS-3 with a Shadow DS-3 as the backup. The Shadow DS-3 is only to be used in the event the primary fails, so we are manually setting the MED to poison the path through the Shadow DS-3. This...

Is it possible to do automatic discovery of the network like HP Open View with Cisco Info Center?If yes,how?

Hello to all. This may seem somewhat silly but I'll ask it anyways. We have a frame relay connection to each remote site backed up by ISDN. I have looked through the Cisco site and cannot find an answer-How do you switch over when your frame rel...

I am running CW2000 suite on HP-UX 11.00.I am concerned that the ANI discovery is being done to quickly and I am not seeing the whole picture. I cannot find anywhere to change the discovery period. It takes about 2-3 minutes to discover a network wit...

Hi All,I want to view the events log of router 3640. As there is not enough memory in the router to store history of all the events, how can I store events logging to remote server. What sort of software do I need for server (Windows NT). Is it Cisco...

Hi All,I have two 6509's, with two Supervisors and Highavailability configured across the SUp's on a box and HSRP across the four MSFC modules. I have configured HSRP for load balancing, such that all ODD VLAN's have the primary router on one box and...

Hi, Do I need to configure bridge group (irb)in 4908G if I have to pass Vlan information from one switch to another switch that are connected to 4908G?regards,Silju

Dear all, Does anybody have any idea if BPX 8850 can