Other Network Architecture Subjects

I am tring to find the commands to upload a file from a server to flash on a router. Where on the server does the file have to be? I have tried copy tftp flash: but I keep getting no such file or directory.Mike

Which command configures directed broadcasts on an interface?A. ip int broadcastB. ipv6 unicast routingC. ip helper addressD. ip directed-broadcastany idea regardsNeo

I receive this message when booting my cat3550.I have tried to load different images but no success :(Can you helpdesk please?Would you like to enter the initial configuration dialog? [yes/no]:=== Flushing messages (00:00:42 UTC Mon Mar 1 1993) ===Ci...

I have a reflective access-list in a switch doesn't seem to work. What I want is allow our campus traffic (141.225.0.0/16) to flow freely, and block outside traffic come in except for certain users. Allow inside network (141.225.216.0/24) to go outsi...

Hi Experts!i need a useful links to expertise my self in the folowing Topics:route mapaclNat10xs for ur help

I have a Cisco 6509 w/ Sup II that was configured for TACACs. This person is no longer available. SO when we reboot the switch and try the break key does not do anything. We cannot log into the Switch to make any changes, thus getting into ROM MON...

HI!PS Throw Light to the following SCenario:I Have 5 distribution switchs(6509-sup20) connected to Core switch 6509-sup20.the routing protocole its EIGRP.I SENT THE Following Network as a summary to the CORE:DS1)10.11.0.0:DS2)10.12.0.0:DS3:10.13.0.0:...

I have been told with isdn you need to have same subnet either end of the dialler, is this true ? and does that go for both BRI setups and dialler interfaces ?

I m looking for important topic and tips to pass CCIE written R&S, I posted the question on certification side of forum but got no reply.Thanks

Hello,I?ve pluged in a straight-through cable on my 3560 switch to connect to another switch but the there is no link at all , is there a console command to change the config of the fa0/1 port so that it makes the crossover by software?? i have trie...

In OSPF area 0 is the same as area 0.0.0.0, Am I correct?

Hi, I am unable to run IP Routing command on my Cisco 3550 switch . Do upgrading of IOS will help me ?regardsNeo