Hi all, can anyone tell me how and why we can edit named access lists, I have heard that it is much easier to edit a named access list than a numbered one
I have Cisco 4506 with Sup V. It is has been joined with one of the VTP domain, but the switch is in Client mode. There are around 10 switches which are connecteing to that switch with trunk ports. The switches which are connecting, some are in Tran...
HI, I have a 6500 switch, It?s working with CatOS 8.3(7), do you know a command to clear counters reported by snmp, I only know the command clear count mod/pto and the output show me:This command will reset MAC and port counters reported by the CLI f...
This happens on two core cat 6500 switches. Customer sees no impact to users. Both switches show this problem and both switches rin CatOS version 8.4(2a) There is defintely no spanning tree loop in the network. Will pruning the VLANs help?
on my router, if I am only dialling one destination, do I just set the connection on my bri interface, whereas if i am dialling 2 destinations I would need to use dialler interfaces, is this correct ?thanks
Hello, i was trying to recover a password on the 1760 router and entered confreg 0x2132 by mistake. Now the router won't boot up at all. Is it toasted?
HelloI have configured GLBP between 2 6500 trougth 3560 and 4500 switches. my problem is that muticast traffic is propagated to all access ports eq PC any IP phomes recive GLBP traffic.Does anyboby now how to disable propagation of GLBP muticast pack...
Hi,I have an issue with a bgp session. i discovered that the bgp session flaps because hold timer is 90 sec and keepalive timer is 30 sec. I try to change these timers but the router doesn't change them. It follow like first.Can I do to change this?C...
How does one tell if a older 2501 & 2509 need a newer rom upgrade?Should I get the rom upgrade and not worry about ? will need to max outram and flash.Bootstrap says it is 5.2(8a) & 10.2(8a).##############################Router 3 Cisco 2501##########...
Hi every one..I am facing an error as it seems in one of my customers 2970 switches. There is a single fiber interface configured and connected to the Catalyst 6513 backbone switch. The fiber LED blincking in Orange or Amber. What could be the reason...
I am trying to power a door entry system which is 802.3af compliant (clas 3) from a 48 port 3560. It works on a 24 port version and on an HP switch but it will not work with the 48 port variant. The error log says "power Imax error". Looking at the d...
