I was told that it is a good idea to run etherchannel on my trunk links so if one interface goes down it will still work, is this true and how would i configure it ?
I was told that it is a good idea to run etherchannel on my trunk links so if one interface goes down it will still work, is this true and how would i configure it ?
Hi,is 802.1q Tunneling -as for a Cat3550 Switch- supported on Cat2950G-24-EI platform?What would be the "best praktice"? restrictions? ...?regardsFrank
when Im using hsrp, I know you put real and virtual interfaces on the routers, are the real ip addresses used for management, and should I be able to ping all the real addresses ?
Hii have already install the native IOS On the PCMCIA.NOW I Want to copy a small IOS From the tftp to the bootflash via a copy command.when i finish the copying now do i need to issue the following commands:boot system flash bootflash:<file name>boot...
Hi Expert!i have configured HSRP On the 2 6509 switch,the 2 switch connected 2gather via etherchanel(2 phisical link).the timers & hold timers is set to:standby 1 timers 2 4.....................now when i disconect the active switch;i receive 6 time ...
Hi Q1)how many Physical link the Etherchanel support?Q2)Every 1 TimeOut how many Milisecond?10xs
Hi all, can anyone tell me how and why we can edit named access lists, I have heard that it is much easier to edit a named access list than a numbered one
when I set up my BRI interface, does it have to be on the same subnet as the other end ? or is it recommended
Hi allcan anyone tell me what methods of encyption I can use between 2 of my wan sites to protect my data ?cheers
HiI want to know how can I limit to 256kbps a specific port on 3750..as you know the service-policy output is not availableregards
I have Cisco 4506 with Sup V. It is has been joined with one of the VTP domain, but the switch is in Client mode. There are around 10 switches which are connecteing to that switch with trunk ports. The switches which are connecting, some are in Tran...
HI, I have a 6500 switch, It?s working with CatOS 8.3(7), do you know a command to clear counters reported by snmp, I only know the command clear count mod/pto and the output show me:This command will reset MAC and port counters reported by the CLI f...
I want to put a 2nd super ws-x4516-10GE into 4507R. Is there any service outage during the sync? Thanks.
This happens on two core cat 6500 switches. Customer sees no impact to users. Both switches show this problem and both switches rin CatOS version 8.4(2a) There is defintely no spanning tree loop in the network. Will pruning the VLANs help?
on my router, if I am only dialling one destination, do I just set the connection on my bri interface, whereas if i am dialling 2 destinations I would need to use dialler interfaces, is this correct ?thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
09-23-2024 02:17 AM | ||
08-07-2024 06:15 AM | ||
07-17-2024 11:08 AM | ||
05-29-2024 04:52 AM | ||
02-14-2024 04:00 AM |