Other Network Architecture Subjects

HelloI would Like to Know If CISCO support ONE to MANY VLAN MAPPING ( VLAN TRANSLATION)thank you for Support.

Hey guysI have one L3 Router from Cisco and two companies. Company two is joining our office in the next months. Company two should have some vlan networks and access to our Firewall and the Internet behind.  Now to question: Is there a better way to...

So, I am getting this error on Prime and it says this:"Interface'switch name'/GigabitEthernet4/0/3:value of Interface Inbound Errors = 100%violated the set threshold: 25%. Additional:InPktErrors=100%, OutPktErrors=0% -Automonitoring - Link and Trunk ...

Hi There I have two Cisco SFP modules GLC-BX-U. One have part number 10-2094-02, other have number 10-2094-03. What is the difference between them? Best regards

Hello, Just want to clarify: in CCW when I configure either a 4351 and 4451 ISR voice gateway, I can use the 2x NIM slots for voice cards/modules and 1x NIM for UCS-E blade. If I want the ISR to support 2x additional voice cards/modules, can I just u...

Hi Techguys,I have Core switch with NTP Master and Layer 2 switch is client for NTP Time synchronization. Clock is synchronized but time in not correct on the client.CORE configuration:Interface loopback54 (172.16.10.254)ntp broadcast version 2ntp so...

Hello All. I have EHWIC-4G-LTE-G in Cisco 1921 and problem: #sho invNAME: "CISCO1921/K9", DESCR: "CISCO1921/K9 chassis, Hw Serial#: FGLxxxx, Hw Revision: 1.0"PID: CISCO1921/K9 , VID: V05 , SN: XXXXNAME: "4G WWAN EHWIC - Global Multimode LTE/DC-HSPA+/...

Hi,I am trying to make Android ACTS setup for WiFi testing. I tried with setup as below:Android DUT (debug) <=> Ubuntu Machine + Python + ACTS "tools /test/connectivity" <=> Cisco WLC2504 <=> Cisco AIR-CAP2602I-A-K9  As per the config json files, Acc...

I have an EHWIC-4G-LTE-A I am using to connect to an LTE/HSPA provider (non ATT) and am able to receive an IP from the ISP, however I'm not able to ping out of the interface to the internet nor am I able to ping the interface IP. I'm about to check w...

Hello,  so I need some serious help here! Ok so not just me, but your help would be helping more then me.  Background, ok so I am a student at Melbourne Australia’s tafe (adult education) holmesglen campus.  Due to COVID-19 situation we have been all...

Hi Guys,I found some problem in my lab.When I attach switch between two routers. Router doesn't form HSRP Completely as appear bellow (Standby Router is unknown). My network working good (but my VPC at far right not consistent when choosing DG. I che...

Hi, On a new Cisco C1000 switch, what is the purpose of the above policy-map as part of the auto qos, from what i can see even when its assigned to a client-facing interface there are no actions other than identifying the traffic, am i missing someth...