I'm trying to connect to my PIX 506 using the console port which is an RJ45. I've looked into the shops and found the adapter, but you have got to do the wiring yourself. Is there someplace where I can see the pin configuration for the serial?
Hi,I apoligize for my bad english!!I must do a complex VPN between two pix where I am oblige to do NAT. However I have a problem with the NAT. In fact I want to relocate my subnet towards a virtual network. I will do it with this commands : Global (o...
I am trying to get a 3005 to establish a tunnel to an IOS box.Here are some logs from the 3005 debug...528 04/06/2003 08:16:20.380 SEV=9 AUTHDBG/70 RPT=2 Auth Server e44af4 has been unbound from ACB 1e0001c, sessions = 0529 04/06/2003 08:16:20.380 SE...
Hello, i have a problem with the PIX MailGuard Feature. When i have this feature enabled, then i can't send mail with SMTP Auth. It's a bug or a feature? ;-)Plan cisco a implementation for MS-Exchange with SMTP Auth?
I have two sites in which I'm managing & monitoring my CSIDS appliances with VMS 2.1 IDM & Security Monitor (W2K SP3). When I connect to the Cisco Works servers (either one) via the web interface (port 1741) I am experiencing extremely slow response....
I currently have my pix setup for VPN, I want to add an ipsec tunnel to another pix. When I try and add the "crypto map newmap 10 ipsec-isakmp", I lose ALL connections through my firewall. When I add "crypto map newmap 30 ipsec-isakmp" the pix takes ...
Does anybody know if it is possible to send syslog messages directly from the IDSM or alternatively, if it is possible to accept the postoffice messages using a syslogd style service on a unix/linux platform.
I have a crypto config that works fine with a remote CheckPoint Firwall:-------------- \/ CONFIG 1 \/--------------------crypto isakmp policy 5 encr 3des hash md5 authentication pre-share!crypto isakmp key cryptokey1 address 1.2.3.4!crypto ipsec tr...
I was hoping you could tell me when MC and SecMon 1.1 for VMS are expected to be released? The "undocumented features" in 1.0 are impacting our monitoring capabilities greatly.Thanks in advance.
Hi,I have to backup a system, where Sensors an Blades are working. I want to know, if one of my Blades fails, can i migrate the configuration to a bakup Network Sensor? I guess, it's not a problem, but I want to be sure!Thanks!
I have IOS 12.13T and tried also with 12.15T, Cisco 1710.If I issue a debug ip packets, I do only see the outgoing packets, not the incoming ones. Any idesSorry, not really a security related issue, but I did't find where else to put this question.th...
