Other Security Subjects

pix syslog message 2003-03-31 15:30:21 Local4.Notice 192.168.253.253 %PIX-5-304001: 61.1.180.220 Accessed URL (my web site ip address ):/default.ida?XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX...

I have two sites in which I'm managing & monitoring my CSIDS appliances with VMS 2.1 IDM & Security Monitor (W2K SP3). When I connect to the Cisco Works servers (either one) via the web interface (port 1741) I am experiencing extremely slow response....

I currently have my pix setup for VPN, I want to add an ipsec tunnel to another pix. When I try and add the "crypto map newmap 10 ipsec-isakmp", I lose ALL connections through my firewall. When I add "crypto map newmap 30 ipsec-isakmp" the pix takes ...

Does anybody know if it is possible to send syslog messages directly from the IDSM or alternatively, if it is possible to accept the postoffice messages using a syslogd style service on a unix/linux platform.

Does anyone knows what is the maximum PPTP session at the same time for a PIX515? thanks

I was hoping you could tell me when MC and SecMon 1.1 for VMS are expected to be released? The "undocumented features" in 1.0 are impacting our monitoring capabilities greatly.Thanks in advance.

Hi,I have to backup a system, where Sensors an Blades are working. I want to know, if one of my Blades fails, can i migrate the configuration to a bakup Network Sensor? I guess, it's not a problem, but I want to be sure!Thanks!

HiMy 765 shows the port 023 / telnet openI have enabled a password, but is there a way as to close / block this ?Thanks for you help Robert

I have IOS 12.13T and tried also with 12.15T, Cisco 1710.If I issue a debug ip packets, I do only see the outgoing packets, not the incoming ones. Any idesSorry, not really a security related issue, but I did't find where else to put this question.th...

Is the beta available for download anywhere. I know I will need the smartnet for the full release. Again I am still under the assumption that 6.3 is still in beta. Thanks.

Has anyone had a problem with the recent change in Mircosoft not installing its VM with the IE, you have to go get Sun Java. The VM worked fine with the PDM the Sun Java doesn't work. Anyone know if a upgrade in Pix firewall addresses this issue?I...

Here is my config on supervisor II on 4006 switch Console> (enable) show spanDestination : Port 4/10Admin Source : VLAN 2Oper Source : Port 2/3,2/5-6Direction : transmit/receiveIncoming Packets: enabledLearning : enabledFilter...

Hi,I am facing problem with pcanywhere connection through my PIX firewall.I have an access-list which says : access-list permit ip any anythe pcanywhere works fine with this.now In place of "permit IP any any" , i want to allow ports 5631 and 5632 ...