Is there a whitepaper at Cisco that points out the "best practice" for security on a medical or healthcare grade network? This would be enterprise level also would work. (but HIPAA compliant)Thanks!
Do the IOS Firewall Features on the router enough to use instead of PIX? For exampleCan i use the CBAC for large scale Network or i should use PixFirewall?And if i use the CBAC which router series well be ok for heavy traffic
I have a router interface configured with the following access list:access-list 101 permit tcp any any eq 23access-list 101 deny ip any anyeffectively, telnet is allowed and all other protocols are denied. when I start a debug on this access-list (de...
I have two campuses, each with their own 100Mbps Internet connection, that I would like to configure for Internet redundancy. My current setup consist of a split class C address block where we route addresses 192.231.40.1 - .128 to campus A and addr...
Hey folks,I have a site-to-site IPSEC VPN using 2 catalyst 6500's running IOS 12.2(18)SXD7b on each end. After reviewing the syslog files this morning, I noticed that for the last 4 days at approximately the same time each nite, my router reports th...
I am trying to upgrade a MARS-20. No matter what command I put into the cmd line I get the following error: Program aborted due to: ORA-01033: Oracle initialization or shutdown in progress.Has anyone seen this, or have any ideas on how to resolve?Th...
HiI'm running a MARS 50 at an average 70% CPU load during full production. I've always felt navigation through the web interface was a bit slow, not just waiting for the mitigation paths to draw but the whole thing. A few days ago I tried Firefox and...
Has anyone else seen a problem with the Cisco VPN client versions 4.8 and 5.0. We have always used the NAT-T successfully. After upgrading to version 4.8 and 5.0 the UDP connections no longer work. TCP works but UDP doesn't. All of the previos older ...
Hi, I'm using 1841 router.My question is I'm not able to configure SSH in this router ,Any IOS problem? Sh versionCisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(1c), RELEASE SOFTWARE (fc1)
I have an 837 (12.4) connected to a DSL provider. The assigned IP address is dynamic. I can access to the router and network behind 837 with the VPN client. While connected with the VPN can not view public hosts (browse the web). From what I can ...
Hi AllIs there anyway I can integrate my content engine logs with Active Directory? I would like it so that when a log is generated it shows the username and computer name that it gets from AD. I have setup authentication using LDAP but am not sure...
I am setting up 4 tunnels between my ASA and 4 Checkpoint remote sites. They just need access to 2 hosts. They will only accept public ip addresses so I am trying to nat the internal hosts to public addresses and force down the tunnel. When my sit...
Hi, I've just installed CSA agent on a host and right away CSA has detected the dsload.sys has modified the kernel and put the host into rootkit system state. I've searched the sites and found out dsload.sys is belong to Oracle however I am not able ...
We have just installed a new ASA5510 and I have a problem with I think Natting. Forgive me if its really simple but I have next to no experience of Cisco boxes.I need to allow SMTP from an outside link. Its not the Internet. The source IP is 172.24...
