Other Security Subjects

Hi, I use a box to provide NTP services to my routers. Using the following command router(config)#ntp server 1.1.1.1 preferI configured my routers to sync with that Box. I just found out that my routers are now accepting NTP sync requests!! Is this a...

Hi we have a 506E but have recently purchased a 515E, I have been religiously thinking if it ever goes down I will have the config to copy back in. so thinking this was possible I have thought that I could simply load the config onto the new 515E , n...

my outside nat interface e0 is configured to receive its address via dhcp, from the outside network. How do I configure an access list to allow the address assignment to make it back to the router? As long as I don't assign an inbound access list i...

I'm using TCP to communicate with my syslog server. I understand that if the communication is lost, that the PIX will cease to forward traffic and am willing to deal with that. However, what if communication is lost, then becomes available again? ...

How do you go about setting up CEP certificate enrollment between Cisco Routers and up a Microsoft CA? What am I doing wrong.Config On The Router ip host MYCANAME [ip address here]crypto ca identity CANAMEenrollment url http://CANAME:80/certsrv/mscep...

I have a need to allow users on the inside interface access to a web server in the dmz using the global address. I used the "alias" command. The relevant config lines I put are as follows:static(dmz,outside) 205.242.218.70 172.22.1.11 netmask 255.255...

PDM loads fine on one machine (WinXPPro, MSIE v6.0.2600), but won't load on another machine (WinXPPro, MSIE v6.0.2800). PDM also won't load on Netscape. PDM allows me to log in, launches the startup window, the information window, then hangs on "load...

Is there an SNMP OID that one could use to query the connection table that would give the results of source IP and port number? What about other methods?Thanks,RJ

I receive the daily alarms report each day without a problem, however I noticed today that I'm not receiving any details from 10/21 onward within these reports. There are no entries for these dates, but I know there have been alarms on those days. ...

say a small company with a 2 interface 2600 router is hosting a www server and also requires access to a ssh server. Please set aside the ideal 3 interface DMZ setup for a moment and just go with me on this. truncated config follows:ip inspect name...

Hi I am adding IDS 4235 v4.0 to VMS 1.1. And when it asks for Sensor version, VMS 1.1 is only listing 3.* versions in the list. Also I am getting some timeout (60 sec) when I am trying to discover sensor settings while adding the sensor in MC. In the...

Hello,Is there a way to reload a PIX from the PDM CLI? If so could someone tell me the comand Combination?The only way I can reach this device is via the PDM from my current location. Thanks all, Duane

Anyone have luck installing the S58 update from IDS MC to 3.x sensor? I have tried several times and it seems to "erase" my other signatures. Im going to try downloading it from the site again but I attempted installing it several times with the same...