Other Service Provider Subjects

Dear Concern,A few days ago I've created a zone in SCABB (SE:-1.7.2) which is contain a <&> character. After that I'm unable to retrieve SCABB. SO now I want to remove the bug from SCE . How can I resolve the problem or remove the zone CLI mode? With...

Hi Pro, In ASR1k, is it possible to build an aggregate service policy that limit the total bandwidth (either inbound or outbond) utiliztation of a group of sub-interfaces?I have a customer who has 3 circuits terminating on 3 of the tens of sub-interf...

our cisco 7613 has about  4.5 Gbps  Tx/Rx IP traffic in total, and we run ospf with other cisco cloud for routing I list in the following some our router show.what is your idea about our high cpu usage .Is it in normal range with the listed cards and...

Hello. Just starting with ISG.   My final goal is to force ISG device to periodically check if user still has access to the service without interrupting pppoe session. if user access should be prohibited by some reason, he should be redirected to bil...

Hi Guys, I have a question: which parts of ASR1K can be affected by ROMMON upgrade ? can it affect on operational level or just can effect on booting of linecards ?  Cheers,M

Can anyone tell how ISP is shaping bandwidth in FTTB deployments if users need several ip addresses and x amount of speed for that devices in total? what's best practices, catch users via mac-addresses or etc.... ?

Hello Could anyone help with a problem. I am using CoA "subscriber:command=account-logoff" command for PPPoE and IPoE session termination. Sessions are terminated successfully, but Acct-Terminate-Cause field in Accounting-Request (Stop) contains the ...

Hi Guys, asr1000 hw-module slot location shutdown vs reload vs reset ?especially after ROMMON upgrade. Thanks,M

Need an IR Code for a set top box (Explorer 4642HDC) to allow my DVD recorder to change channels. 

Is it possible to Configure DCM  9901 port as I/O?

Hello Is it possible to configure l3-connected ISG dual stack on ASR1000? 

I would like to enable MVR on C4507R+E on trunk port. Actually my current network setup is connecting two uplink from this switch to aggregation router as layer 2. And CPE is connected down this switch with private vlan configuration. I have attached...

Hi all , I would like to ask you do you know or did someone meet whit this issue on CMTS 7246VXR  IOS : ubr7200-ik9su2-mz.123-23.BC10.binIssue is that CMTS sends DHCP packet with Hardware Code Type 0  and it should be 1 , so that huawei router report...

Hi,          I'm getting below logs in my router frequently and BGP flaps. could someone tell me what are the possible causes of this issue. Oct 2 02:33:50: %BGP-3-NOTIFICATION: received from neighbor 192.168.181.217 4/0 (hold time expired) 0 bytesOc...

Hi all,Please I need your advise regarding the course  or Training to do if I want to purchase directly my IP block  from the Regional Internet Registry (RIR) and assign them on my router?Sorry, I think my request make sense.Thanks