Hello, I have a firepower 1010 and I tried to upgrade it, later it began to reboot infinitely Reading the cisco documentation I applied upgrade revert after that, the console appears: firepower-failed # nor does it allow me to apply more commands onc...
This is a relatively new remote site and up 25 days. I was successfully able to install and configure Anyconnect VPN. It is currently running 7.2.8-25 out-of-the-box from Cisco. I have it staged for 7.4.2.2-28 Cisco's gold start. Show Disk: is sh...
we are migrating to a new cisco firewall (FTD) 2110 from cisco 5515X. What are the precautions need to be taken care, and how should I start the process when I get the New device?
My ASA running on 9.16.4 found the below vulnerabilities on my WAN IP, kindly check and help us to mitigate these Cisco Adaptive Security Appliance Remote Code Execution and Denial of Service Vulnerability (cisco-sa-20180129-asa1)CVE-2018-0101 TLS Pa...
I upgraded FTD version 7.2.8-52 to board 7.2.9-44 and got this error
I need to pull all video for a specific date 24 hours, across 200+ cameras. Pulling clips in SASD is going to take forever. I can easily pull the native files using sftp /Media1, the files all have a .smd extension. Is there a program that will ope...
Hi GuysWhen backing up the FTD, it appears there are 2 ways of backing up the config, the full backup and the export of the config.What is the difference between the 2 please? and when would you use one or the other?Also, I assume in the event of a h...
I always understood that you never leave an interface exposed. If you want to modify an ACL on an interface you create a new one and then apply it to the interface before deleting the old ACL. This also protects you from disabling the interface in ca...
We have VSOM 7.14 - and since Cisco is no longer supporting VSOM, does anybody know of any third party company that can assist us with VSOM?
Hi Guys, I am supporting a client who forgot their admin password for the VSOM, but I can't see a way to reset it in the user guide. Any advise? Thanks. Peter
So I've deployed an ASAv in Azure and it's been assigned a static ip for it's management interface. I'm able to reach the unit and configure it as normal, but I'm not able to remove the "no management-only" command from "interface management0/0". I...
Hello Team,Getting attached error while I try to configure Remote Storage on FMC for backups.Am using windows server NFS for this.Kindly assist.
After configuring Taccacs on 2960 switch still the same secret password are working. does anyone know what is the problem of this. Please see below for my configuration.tacacs-server timeout 15tacacs-server directed-requesttacacs-server key ------ta...
i have a problem with CPAM system. I have cisco gw reader with each door and when the door close/lock, it show status door forced open. I have check check the wiring and configuration still couldn't solve the issue. May i know is there anyone facing ...
