I thought I had read some where that I can use PoE to power the Cisco Physical Access gateway along with a local power supply to provide some power fault tolerance. Is this correct?
We have an issue where the "Site Name" in CPAM isn't correct. I was told the only way to get this changed is to do a system reset, how is a system reset done? A separate but related question that I will eventually find out, does a restore include th...
I have a customer going to install CIVS-IPC-2500W at outdooor.I have read through the datasheet of CIVS-IPC-2500W but can not find any information about suitability of antenna for ourdoor deployment.My question will be does antenna come with CIVS-IPC...
Tool does allocate IP address to a single 2500 camera however nothing is displayed in the discovery tool. Only one interafce is enabled and the rest are disabled. Local interface does have ip address of 192.168.0.2/24. What am I missing? Also what wo...
Hi!I have successfully installed all needed components of the VS suite (VSOM, VSMS and VSVM) after that I have successfully configured 4 cameras. I can see previews on the Camera pages, but when I try to view cameras using Operator Page, I receive ju...
Does anyone know if there are any SNMP MIBS available or published for the Video Surveillance Manager and/or Operations Manager? If not today, are there plans to?Thanks,Vance
Hello I need to know why only I can to record video alone once for each camera. In other words, I have to erase the video previous of each camera to be able to record a new video.
Customer attempts to run IPICS 2.1(1) install. The install gets near the end and gets a failure indication that ippe "preconfig.sh" fails to complete. How do I make it work?