Physical Security

Hello. I'm running VSOM/VSM 7.9.1 on a single server.  I am unable to log into the webui.  When I load the page I get an error "The requested page is not available. Please check the URL"  I can access the server through putty.  This is what I see so ...

Hi and thanks for reading.I'm an IT manger/Sysadmin at a site trying to figure out how to deal with an operational problem. CCNA, but by no means an networking expert.It's a hotel, and we have 500+ TVs running on CAT6. Due to PCI, we need port securi...

Greetings all,I inherited a VSOM environment that is in a suboptimal state and I'm looking for pointers to get it back in order. This was an old install base originally deployed on 7.6 (or thereabout) and running 7.11 when I took over. I upgraded to ...

We have cameras recording 24/7 but at one point had some recording only on motion, so I know that part is possible.  Is it possible though to record 24/7 but have it highlight motion in the timeline, ala some of the more modern products (Meraki, etc)...

So, I've been chasing the dragon on this one for a while now, and I really haven't reached a clear resolution. Sure, I understand that port security is a physical layer of security, based on the port and device attached and nothing else. So, how do I...

Hi All,  I have purchased new Cisco 1010 FPR Firewall and i have two ISP's in my office and i want to configure it both as redundant.Like one goes down second will be live automatically and again first will up it will restore it as primary.Could you ...

I know this is an old piece of equipment, but here goes anyway.I have a 2830 PTZ that appears to have a low res image in VSOM; however if I look at it in the IP camera setup software, the image is very crisp.  I'm not sure I understand what's going o...

Good day!We are planning to buy Firewalls cisco firepower 1010 for bank branches.We need a consultation!We want to buy 2 (two) 1010 firewalls for each branch.If we buy 2 (two) pieces of this model for each branch, do they allow us to install them in ...

Hi Team,  we use a FTD 2110 and manage it via FMC (both Version 6.6.4). We have a SNMP Monitoring tool and need to know what OID we can use to get Hardware Health device status: power supply. fans, CPU, etc.  Does someone know which snmp oid´s can mo...

Hello  i would import a wildcard certificate bu i got this error message  Core-Switch-1(config)#$-Com pkcs12 flash:wc.at.pfx password 1234% Importing pkcs12...Source filename [wc.at.pfx]?Reading file from flash:wc.at.pfx% Warning: CA cert is not foun...

Hi there, So my questions is regarding port-security. Is this function purely physical for the device attached only? I would like to know, if I add port security on say interface 1/0/48, will the interface receive broadcasts from other macs if say I ...

Have a customer that is currently running VSOM 7.9.  Majority of their cameras has a "Red X" next to the cameras that are in critical state.  Not able to see the live view of the cameras.  The cameras are connected to the network and respond to pings...

Is it normal for the fans on my cisco ise 3415 appliance to be noisy?