Routers - Small Business

Hi All, I am trying to configure my RV320 as an OpenVPN server. This is the second RV320 i am configuring and with the first one i had no issues at all. Setup is pretty straightforward: Password only, i will reconfigure to use certificates at a later...

HiDoes RV325 support one-to-one NAT within VPN tunnel?ThanksPierre

I recently install a router Cisco C881, I configured DHCP correctly and when I'm connected directly to the router, everything works ok, even the ip it assigned to my pc it's within the range. The problem comes when I'm connecting through the switch,n...

What size plug and what polarity is needed for the 3825?  I know it's 15 volts and 1.2 amps.  I have a power adaptor with that voltage and amps but it does not plug into the 3825.

I have 3 gateway to gateway connections all working but I cannot get the QuickVPN to work. The address at the main location I am trying to connect to is 192.168.1.X The other 3 locations are 192.168.2.x, 192.168.3.x and 192.168.4.x I have tried from ...

Hello, Upgraded yesterday my RV325 to the new firmware (v1.3.2.02). A little look in my log, I see this line repeating a lot: RV325: kernel: xt_TCPMSS : bad length (xxx bytes) After double check: this error has nothing to do with the firmware, it fl...

I have a client moving from a PIX to a ASA 5506. I have internet routing properly, and email flowing in and out of their Exchange server. I need help translating a PIX static(inside,outside) into an ASA NAT. I also need to allow RDP on port 3389 to t...

Hello Can you recommend vpn client for cisco rv320 model. We have 30 traveling workers. I tried shrew vpn client, but only managed to create tunnel for one user.

Hello, I'm brand new at configuring Cisco routers and I'd like to double check to make sure I'm on track especially with the dhcp, gateway, NAT and route configurations. Here's my situation. Using a 2911/K9 router: ETH-WAN on g0/1 is a dynamic IP fr...

Hello I am trying to setup the DHCP Relay option for the RV130 Firewall, and I am not having any luck.  I created 2 VLANs (10,20) on RV130 and VLAN 10 has the DHCP server and VLAN 20 is where I would like to have the host machines receiving the IP f...

Hi Cisco Community After upgrade RV320 to firmware 1.3.1.12, the RV320 will not boot up. The PWR led is flashing and the DIAG led is red. We need to downgrade to v1.2,1,14 via TFTP, to get the RV320 run again. Hardware version 01 Any proposal to solv...

Hi, is it possible to configure a vpn gateway to gateway between two RV320's when only one router is connected to an external public ip?  I need to set this up where one RV320 router is connected to a public LAN behind a private router. Can this be d...

Hi, one of my customers is using a Cisco ISA570 which originally has the security services with TrendMicro (embedded in the system).   I cannot find a way to renew the same service.  It looks like it is not being offered anymore or I am doing somethi...

 We have a Cisco RV016 that we have used successfully for several years to route email and other traffic from different ISPs.  We are in the process of changing the name of the firm and have acquired a new domain name,  yyyy.com, that will be used am...